User manual CISSELL 36BD30

[. . . ] The warranty period on each new replacement part furnished by Cissell in fulfillment of the warranty on new equipment or parts shall be for the unexpired portion of the original warranty period on the part replaced. With respect to electric motors, coin meters and other accessories furnished with the new equipment, but not manufactured by Cissell, the warranty is limited to that provided by the respective manufacturer. Cissell's total liability arising out of the manufacture and sale of new equipment and parts, whether under the warranty or caused by Cissell's negligence or otherwise, shall be limited to Cissell repairing or replacing, at its option, any defective equipment or part returned f. o. b. Cissell's factory, transportation prepaid, within the applicable warranty period and found by Cissell to have been defective, and in no event shall Cissell be liable for damages of any kind, whether for any injury to persons or property or for any special or consequential damages. [. . . ] Take steam hose (3) in one hand and iron cord in other and wrap iron cord around steam hose at least twelve times. Press hose cord spring clip (5) around iron cord to help hold cord in position. Page 8 F. Take support spring (6) and connect S hook to hose support clamp (7) pinch S hook closed. Connect Low Boy (8) to steam line as illustrated on following page. Insert support string (6) end into Low Boy (8) support spring plate and tighten square head set blot. Slip steam hose (3) over Low Boy (8) steam tube and tighten hose clamp (4). Connect iron cord (5) to Low Boy (8) electrical box as illustrated on following page. Page 9 Ref. J17 LB7 GSB145 J1 J42 S05 K382 PIU23 Description S Hook Support Spring Hose Support Clamp Hose Cord Spring Clip (3 required) Hose Clamp (2 required) Steam Hose (5 ft. ) Cord Assembly Iron Rest Steam Electric Iron (See attached) Low Boy (See attached) Page 10 TYPE D LOW BOY ASSEMBLY FOR CISSELL STEAM-ELECTRIC IRON WITH ELECTRIC THUMB SWITCH LB148 Solenoid Lowboy Valve 120V. 1-21 Support Rod and Hose Assembly - LB105 Consists of Ref. 22-27 For Lowboy & Condenser Ass'y Electric Box Assembly Consists of Ref. 40-56 LB225 - 120V/50/60 LB226 - 240V/50/60 Ref. IMPORTANT Operating Steam Pressure - 5 to 100 lbs. Steam Return - 1/2 Pipe Connection. Attach Steam Hose to Steam Tube as illustrated. Push Steam Hose down on Steam Tube just far enough beyond swedge to allow Hose clamp connection. Do not push Steam Hose all the way down on Steam Tube as this will cause hose to burn out. MECHANICAL OPERATION Place iron on rest. Turn toggle switch on (pilot light indicates when current is on); allow iron to heat, set indicator to Rayon. Open steam supply and steam return valves. Wait until iron becomes hot then push electric thumb switch of iron to allow steam to flow from soleplate of iron. Release thumb switch to stop steam flow. Screw valve knob in for less steam, out for more. MECHANICAL MAINTENANCE To replace coil in solenoid valve, remove bolt, cover, leaf spring, insulating washer and coil. Install new coil and replace washer, spring, cover and bolt. To replace renewable valve seat or plunger, unscrew lage hex nut from lower cast body. [. . . ] After use, the old style packing becomes hard and brittle, causing valve stem to bind when pack nut is tightened. Remove hard packing and replace with three new V 13 Split Pack Ring. If leak continues, remove old packing and replace with two new V 30 pack rings. Replace old disc if it is cracked or pitted preventing a perfect seat. [. . . ]