User manual CISSELL ACDCMAN407

[. . . ] Automatic Computer Drying SUPPLEMENTAL OWNER'S MANUAL CISSELL MANUFACTURING ST. COMPANY PHONE: (502) 587-1292 SALES FAX: (502) 585-3625 SERVICE/PARTS FAX: (502) 681-1275 HEADQUARTERS 831 SOUTH FIRST P. O. BOX 32270 LOUISVILLE, KY 40232-2270 THIS MANUAL MUST BE GIVEN TO THE EQUIPMENT OWNER. MAN407 2/97 Page 1 DESCRIPTION The Automatic Computer Drying Control is used to manage the drying and cooling cycles of one clothes dryer. The operator has the flexibility to select either automatic or timed drying and either automatic or timed cooling. [. . . ] Adds 5 Degrees to the differential temperature. Adds 10 Degrees to the differential temperature. Adds 10 Degrees to the differential temperature. The differential temperature is part of the heating logic. The heat turns off when the temperature in the dryer reaches the temperature set for the drying cycle. The temperature has to drop a set number of degrees below the drying temperature before the heat will turn on. The difference between the cycle temperature and the temperature to turn the heat on is called the differential temperature. This control allows the differential to be set between 5 and 25 degrees. The control "sums" the values set on the switches but will not go lower than 5 nor greater than 25. If the sum is less than 5 the control will default to 5. If the sum is greater than 25, the control will default to 25. Page 6 #7 #6 #5 #4 #3 #2 #1 NOTE: CONTROL BOARD AND OPTIONS ILLUSTRATION Page 7 DETAILS OF CONTROL BOARD AND OPTIONS (cont'd) Switch set #2 Switch #8 #7 #6 #5 #4 #3 #2 #1 No Function No Function No Function No Function No Function No Function No Function No Function ON --------OFF --------- Thermistor Calibration To verify the calibration of the thermistor circuit, proceed as follows: 1 Disconnect the thermistor leads going to the circuit board. 2 Short the terminals at JP5 (thermistor calibration pins). 3 Press the "up arrow" and the "down arrow" keys to display the temperature. 4 The temperature should read 158° F. 5 If not 158° F, adjust the thermistor calibration potentiometer until the display reads . 6 Remove the jumper from the thermistor calibration pins. 7 Connect the thermistor leads to the circuit board. Reversing Dwell Time This potentiometer is used to set the dwell time when the dryer has the reversing option. The dwell is the time from when the motor turns off to when it turns on again in the opposite direction. Turning the knob counter-clockwise increases the dwell time and turning it clockwise decreases the dwell time. Computer Reset Push this button if the control "locks up". [. . . ] This indicates that the automatic cooling cycle has been selected. In TIMED mode, pressing and holding this button will show in the display the current time (in minutes) set for the cooling cycle. In the TIMED mode only, the cooling time can be changed by pressing and holding the COOLING TIME button and using the "up arrow" or "down arrow" buttons. These two buttons are used in conjunction with the DRYING TEMPERATURE, DRYING TIME, and COOLING TIME buttons to change the value of those parameters. [. . . ]