User manual CISSELL AOLAUKMAN592

[. . . ] Step #1 Step #2 Step #3 Step #4 Step #5 Step #6 Connect the air supply (3/8) to the press (85 PSI, 6 Bars). Make sure the power switch is turned to off. Remove the access panel from the rear of the press. Connect 110V to junction box located on the inside of the right rear channel leg. [. . . ] Timer T2 is for the dwell time between steam and first vacuum usually set at 2 seconds Timer T3 controls 3 different operations. The first operation T3 controls is the first vacuum and is usually set at 2 to 3 seconds. Timer T3 also energizes Timers T4 and T5 after the first vacuum is completed. Timer T4 controls the release of the press head and also determines when the second vacuum begins. The head lift speed control valve #8 in back of Solenoid Valve SV3 controls the speed of the press head as it begins to lift off the buck to prevent vacuum pick-up of the garment. Timer T4 should be set at 1 to 2 seconds depending on where the head lift speed control valve is set. Timer T5 controls the length of the second vacuum and ends the automatic cycle. Timer T5 must be set higher than Timer T4 in order to get second vacuum. Timer T5 should be set at about 5 to 6 seconds. Page 3 MAINTENANCE AIR CYLINDER No maintenance. IF THE HEAD DOES NOT OPEN WIDE This indicates that one of the reed switch disks has been rotated on the cylinder shaft. EMERGENCY STOP BUTTON The emergency stop button is connected to a reserve air tank. In case of air or electrical failure, or both at the same time, the air in the tank will return the head to the full open position (110 degrees). AIR FILTER The plastic bowl has a manual petcock which should be drained daily. If there seems to be an excessive accumulation of oily water, the air storage tank may need to be drained or the compressor may have bad rings that need to be replaced. Dirty air is one of the chief causes of excessive maintenance. If the air filter cartridge appears to be stopped up, it can be taken out and cleaned, usually by just blowing it clean with an air hose. CAUTION: Remove all air pressure from the machine and air lines before removing the filter bowl. If the bowl appears cracked or damaged, it should be replaced. PADDING No press will turn out quality work with inferior or worn-out padding. Padding that has been packed down too much slows down both buck steam and vacuum. Low spots also tend to show up, giving unequal pressure and poor quality. [. . . ] 2. ) Steam Trap Not Working. Page 7 Trouble Shooting Cont. Press Will Not Work Automaticly (AOL Only): 1. ) Auto/Manual Switch Set To Manual or Defective. 3. ) Check All Timers Are Plugged In Completely. No Automatic Head Steam (AOL Only): 1. ) Head Steam Solenoid Valve #3 Not Activated or Defective. 2. ) Steam Timer T1 In Zero (0) Position. [. . . ]