User manual CISSELL AOLCMAN150139

[. . . ] Set head position switch to middle position. Turn power switch on head should go to normal operating position (about 60 degrees). STEAM PIPING Secure the services of a competent steam fitter. Do not connect with any smaller piping than the size of the connection on the machine. Use traps and check valves on all return lines. [. . . ] The head will release at the time the Cancel Switch is actuated. If the machine is in automatic, it will reset for another cycle. HEAD (TOP) STEAM To apply steam manually push down on the head steam valve handle. When the handle is released the steam will shut off. Automatic head steam is applied when the press is in the automatic cycle and the Lock Switch is released. BUCK (BOTTOM) STEAM To apply bottom buck steam depress the Steam Foot Switch. TIMERS There are five timers for the automatic cycle. Timer Tl is for automatic head steam usually set at 2 - 1/2" to 3 seconds. Timer T2 is for the dwell time between steam and first vacuum usually set at 2 seconds Timer T3 controls 3 different operations. The first operation T3 controls is the first vacuum and is usually set at 2 to 3 seconds. Timer T3 also energizes Timers T4 and T5 after the first vacuum is completed. CAUTION: Never use any solvent that will attack rubber. GRID (HEAD) PLATE The grid plate should be removed when it becomes soiled. It can be cleaned with a mild detergent and water. The grid plate should be thoroughly dry before replacing on the head. REPADDING THE BUCK Center the pad over the buck and bring head down against the pad to keep it from moving. Pull the drawstrings just tight enough to hold the pad in place. If the drawstrings are pulled too tightly, the pad will have a tendency to pull away from the pressing head around the edges. When installing spring hooks, be sure that they are not pulled so tightly underneath the buck that grooves are noticeable in the surface of the pad. The spring hooks should hook around the wire rods that fit the drawstring track of the covers. The wire rods will prevent the springs from causing puckers in the padding. Page 4 Page 5 Trouble Shooting AOL and AU (See Your Related Air Schemtics and Wiring Diagrams For No. s ) Note: A 3/32 Allen Wrench For Adjusting Reed Switches Is Attached To Rotary Cylinder. Head Will Not Close: 1. ) On-Off Switch in Off Position. [. . . ] Press Will Not Work Automaticly (AOL Only): 1. ) Auto/Manual Switch Set To Manual or Defective. 3. ) Check All Timers Are Plugged In Completely. No Automatic Head Steam (AOL Only): 1. ) Head Steam Solenoid Valve #3 Not Activated or Defective. 2. ) Steam Timer T1 In Zero (0) Position. 3. ) Head Steam Cylinder Not Activated or Kinked Air Line From Air Valve #3 To Air Cylinder #20. [. . . ]