User manual CISSELL AUMAN197

[. . . ] Cissell's total liability arising out of the manufacture and sale of new equipment and parts, whether under the warranty or caused by Cissell's negligence or otherwise, shall be limited to Cissell repairing or replacing, at its option, any defective equipment or part returned f. o. b. Cissell's factory, transportation prepaid, within the applicable warranty period and found by Cissell to have been defective, and in no event shall Cissell be liable for damages of any kind, whether for any injury to persons or property or for any special or consequential damages. The liability of Cissell does not include furnishing (or paying for) any labor such as that required to service, remove or install; to diagnose troubles; to adjust, remove or replace defective equipment or a part; nor does it include any responsibility for transportation expense which is involved therein. The warranty of Cissell is contingent upon installation and use of its equipment under normal operating conditions. [. . . ] Launder bag at frequent intervals as determined by its soiled condition. The Cissell Pants Topper bag has a double liner to extend pad life and to distribute steam uniformily. REPAIR HOLES OR WORN SPOTS in bag to extend its useful life: REPLACE when worn beyond repair. A defective or worn bag will cause topper to operate unsatisfactorily. KEEP A SPARE BAG IN STOCK. CAUTION CAUTION Use only genuine CISSELL bags. The fabric for the Cissell Bag is especially woven (and cut to an exact pattern) to give the correct porosity and shape for proper steaming and drying. Rember, your CISSELL PANTS TOPPER depends on the bag for proper operation. Correct padding is necessary to obtain proper finishing. The Cissell buck pad is constructed of a high, heat-resisting synthetic air foam, and perforated for rapid steaming and full air flow through entire buck area. Replace a worn-out pad only with a Cissell perforated pad. Do not use more than 1 pad. RESEALING EDGES FOR STEAM & CONDENSATE LEAKS CONDENSATE When leak appears: 1. Using sealing compound Permatex #2 or equivalent; (3 oz. Fasten plastic sleeve securely with #8 Tap Tight Screw at "A" (Fig. Position end of cloth arm cover in contact with end of plastic sleeve. Using Scotch Brand pressure sensitive Tape #471 or equivalent; (Tape available from Factory) Tape Plastic Sleeve at "B" securely attaching end of Sleeve to cloth arm cover. (Minimum 2-3 wraps) Pull end of cloth arm cover at "C" to remove slack. Tape cloth arm cover at "C" securely attaching end of cover to arm. BEARING ADJUSTMENT FIG. To Adjust Bearing: Remove Top Loosen 1/4" machine screw holding the bearing rod to the metal bracket. Slide screw in hole of bracket to bring the plastic sleeve into contact with the outer face of the arm guide. Hold the "E" Ring on the Bearing Rod against outer face of counterweight and retighten 1/4" screw. Re-install top on machine. RESEALING EDGES FOR STEAM & CONDENSATE LEAKS FIG. Using sealing compound Permatex #2 or equivalent: (3 oz. tubes available from factory) Generously apply sealing compound evenly along of "Leak". [. . . ] Holding circuit for steam relay SR open at contact (relay SR), and the holding circuit for relay AR open at contacts (automatic relay AR) or (air timer AT) 11a. Holding circuit for automatic relay AR open at contact 11b. Holding circuit for automatic relay AR open at contact (air timer AT) 11c. Holding circuit for relay AR open - defective wire terminal connections Inspect contacts. [. . . ]