User manual CISSELL FINTUNMAN67

[. . . ] WARRANTY The Cissell Manufacturing Company (Cissell) warrants all new equipment (and the original parts thereof) to be free from defects in material or workmanship for a period of one (1) year from the date of sale thereof to an original purchaser for use, except as hereinafter provided. With respect to non-durable parts normally requiring replacement in less than one (1) year due to normal wear and tear, including, but not limited to, cloth goods, valve discs, hoses, and iron cords, and with respect to all new repair or replacement parts for Cissell equipment for which the one (1) year warranty period has expired, or for all new repair or replacement parts for equipment other than Cissell equipment, the warranty period is limited to ninety (90) days from date of sale. The warranty period on each new replacement part furnished by Cissell in fulfillment of the warranty on new equipment or parts shall be for the unexpired portion of the original warranty period on the part replaced. With respect to electric motors, coin meters and other accessories furnished with the new equipment, but not manufactured by Cissell, the warranty is limited to that provided by the respective manufacturer. [. . . ] The doors will open, the load will enter the tunnel, the door close, and the finishing cycle begins. Refer to Control Panel Operation page for functions during cycle. While finishing is in progress, load the next loading station. When the first load is finished, machine will stop, then press foot switch or pushbutton again. Doors will open, conveyor will advance, the first load exits onto drop-off, and the second load enters, doors close and cycle begins over. Repeat operation until last load is finished. Press foot switch or pushbutton to exit last load. Experimentation with timer dials and switches may be necessary to achieve desired results for different types of fabrics. CAUTION: For proper operation, time must be non-zero on the three timer dials. Page 15 TROUBLE SHOOTING CHART Machine will not operate. PROBLEM Machine advances to OFF position when started. Electric power off. Door cam out of adjustment (switch not engaged). No time on timers. CAUSE Turn power on. Adjust according to instructions on Page 9. Adjust timer knobs to give nonzero time. Inspect wiring, clean terminals and repair. Check dip switch settings, 3 & 4 should be on, the rest off. Check dip switch settings, 3 & 4 should be on, the rest off. Check dip switch settings, 3 & 4 should be on, the rest off. REMEDY Machine re-cycles continuously. Timing too short on one of the three settings. Start button is stuck or defective. Dip switch settings on timer not correct. Dip switch settings on timer not correct. Dip switch settings on timer not correct. Timing too long on one of the three settings or will not proceed through cycles. No water fog at steam jet; steam too dry. Steam too wet; excessive moisture in cabinet. HOW TO CHECK TIMER 1. [. . . ] SG114 SG37 SG68 SG115 SG87 SG155 Description 4 4 Long 5 Long 7 Long 9 9 Long 11 Long 20 Long HOW TO SERVICE CISSELL WATER-SPRAY GUN: A. Close Spray Gun Valve when replacing Parts on Gun. Do not use Pliers on knurled connections as they can be tightened sufficiently with fingers. To clean or replace Strainer Unscrew Hose Nut on Hose and remove Strainer Clean by blowing out sediment with air hose or mouth. [. . . ]