User manual CISSELL HDMAN2110

[. . . ] HD LAUNDRY DRYER Gas: Natural and LP Steam Electric Technical specifications Installation instructions Operating instructions Maintenance HD110 Cissell Manufacturing Co. 831 S. - 40232-2270 Tel: (502) 587-1292 - Fax: (502) 585-2333 Sales Fax: (502) 585-3625 - Service/Parts Fax: (502) 681-1275 THIS MANUAL MUST BE GIVEN TO THE EQUIPMENT OWNER MAN HD2110 4/06 IMPORTANT NOTES - PLEASE READ For optimum efficiency and safety, we recommend that you read the manual before operating the equipment. Store this manual in a file or binder and keep for future reference. WARNING: Purchaser must post the following notice in a prominent location: WARNING: For your safety, the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury, or death. [. . . ] This process will remove any films or residual coatings left by the manufacturing process. CAUTION Synthetic solvent fumes from dry cleaning machines create acids when drawn through the dryer. These acid fumes cause rusting of painted parts, pitting of bright plated parts and completely removes the zinc from galvanized metal parts, such as the tumbler basket. If the dry cleaning machines are in the same area as the tumbler, then the tumbler make-up air must come from a source free of solvent fumes. ABOVE 2, 000 FEET (610 M) ELEVATIONS ABOVE 2, 000 FEET (610 M) Input ratings shown on the rating plate (serial tag) are for elevations up to 2, 000 feet (610 m). For elevations above 2, 000 feet (610 m), rating should be reduced at a rate of 4% for each 1, 000 feet (305 m) above sea level. Page 30 OPERATING INSTRUCTIONS--TWO TIMER MODELS Page 31 OPERATING INSTRUCTIONS--TWO TIMER MODELS OPERATING INSTRUCTIONS--TWO TIMER MODELS OPERATINGINSTRUCTIONS--TWO TIMERMODELS 1. After loading the dryer with the water washed clothes load, close the loading door. For better drying, do not load dryer with combination of garments that twist. Turn the 60-minute drying timer to the desired drying time. The drying cycle light will be on and indicate the drying. The light shuts off when drying time is complete. Turn the 15-minute cooling cycle timer to the desired cool down time. After the drying cycle is completed, then the cooling cycle time will automatically operate. The cooling light will be on and indicate the cooling of the clothes load. The light shuts off when cooling time is completed. Temperature Selector--Select temperature per type of load being dried in the dryer. (figure 2 on page 26. ) High Heat--Mixed and heavy fabrics, set dial to 195°F (77°C). Normal--Cottons and linens, set dial to 170°F (77°C). Permanent Press Heat--Poly knit synthetics, blends, lightweight fabrics, set dial to 150°F (66°C). Low Heat--Delicate, sheer fabrics, easy-to-dry, set dial to 135°F (58°C). Thermometer--Use this with your temperature selection. Note what temperature is too hot or too cold. [. . . ] 12 13 14 15 16 17 18 19 20 21 22 PART NO. TU4606 TU4934 TU13823 TU3539 TU4606 TU2224 TU13678 TU2226 TU7733 TU13695 TU13647 DESCRIPTION 3/4" x 4" Nipple 1/4" - 20 Hex Nut (Pkg 6) 3/4" x 36" Nipple Burner Orifice 1/4" Lock Washer (Pkg 6) 1/8" Pipe Plug Thermostat, Man. Reset 300° Manifold Mounting Bracket #8 - 18 x 1/2" Self-Drill Screw (Pkg. of 6) Bonnet Thermostat Bracket Mounting Bracket Page 70 STEAM BONNET (4 COIL) 24V - TU13691 REF NO. [. . . ]