User manual CISSELL KMAN589A

[. . . ] Charges for unauthorized repairs will not be accepted or paid by Cissell. CISSELL MAKES NO OTHER EXPRESSED OR IMPLIED WARRANTY, STATUTORY OR OTHERWISE, CONCERNING THE EQUIPMENT OR PARTS INCLUDING, WITHOUT LIMITATION, A WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, OR A WARRANTY OF MERCHANTABILITY. THE WARRANTIES GIVEN ABOVE ARE EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED. CISSELL NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO ASSUME FOR IT ANY OTHER WARRANTY OR LIABILITY IN CONNECTION WITH THE MANUFACTURE, USE OR SALE OF ITS EQUIPMENT OR PARTS. [. . . ] The Lowboy bracket (PR356) has been installed on the table at the factory. Then assemble the iron rest assembly (PR365, PR398 & PR401) to the shaft of PR356. (See Figure 1) FIGURE 1 (IRON REST) Page 6 INSTALLING THE PRESS (Continued) Steam and Vacuum Connections (See Figure 2) 5. Connect a 3/8 inch steam supply line to the press at a recommended pressure of 88 psi (6 bars). Use a reducing valve if needed to obtain the correct pressure. The press uses one boiler horsepower (34. 5 lb/h) of steam. Connect a 3/8 inch steam return line to the press. Install a 1/2 inch steam trap suitable for 88 psi (6 bars) in the line. Connect the vacuum using a 2 inch pipe to the vacuum supply. The vacuum supply should be rated two presses or more. (Example: Cissell Dryset model 2D or larger). 6. 7. FIGURE 2 STEAM & VACUUM CONNECTIONS Page 7 Page 8 Description of the Manual Press The buck of the press is the bottom part of the press upon which the garment is to be placed and pressed. The head is the upper part of the press. The head has a nylon handle used for closing. Three foot pedals are located near the floor at the front of the press. The center pedal is the head locking pedal. The right pedal activates the buck valve which ports upsteam to the buck. One black coated lever is located on the head. This lever operates a head valve for porting steam to the head. One black knobbed lever is located on the head. [. . . ] The set collar on the vacuum valve connecting rod not adjusted properly. Adjust set collar for a clearance of +/- 1/16 inch between collar and operating valve lever. Page 12 4. Vacuum Will Not Shut Off____________________________________________________________ Cause Remedy A. Repair or replace vacuum valve. 5. Wet Spots On Buck Pad & Covering_____________________________________________________ Cause Remedy A. Steam input has a 6 inch riser off of supply header. [. . . ]