User manual CISSELL MAN65

[. . . ] No defective equipment or part may be returned to Cissell for repair or replacement without prior written authorization from Cissell. Charges for unauthorized repairs will not be accepted or paid by Cissell. CISSELL MAKES NO OTHER EXPRESS OR IMPLIED WARRANTY, STATUTORY OR OTHERWISE, CONCERNING THE EQUIPMENT OR PARTS INCLUDING, WITHOUT LIMITATION, A WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, OR A WARRANTY OF MERCHANTABILITY. [. . . ] This will enable you to disconnect the steam connections and service the Cabinet while your plant is in operation. Before connecting trap and check valve to Cabinet, open globe valve in steam supply line and allow steam to flow through Cabinet to flush out any dirt and scale from Cabinet. This will assure proper operation of trap when connected. If steam is dirty, it will be adviseable to install a filter or blow down line ahead of cabinet. After flushing system, install trap and strainer as illustrated. Inspect trap and strainer carefully for inlet and outlet markings and install according to manufacturers instructions. If steam is gravity returned to boiler, omit trap but install check valve in return line near Cabinet. When cabinet is on end of a line of equipment extend headers at least 4 ft. Install globe valve, union, check valve and by-pass at end of line. If steam is gravity returned to boiler, omit trap. Insulate steam supply and return lines for safety of operator while servicing Cabinet. Repair or replace any worn or defective parts. The interior of the tunnel will turn white as the protective zinc oxide coating forms. Do remove lint, dust, and boiler compound or red dust which is entrained by the steam. Touch-up scratches and chips in the paint. A good car wax will extend life of the painted surface. Page 4 Page 5 OPERATING INSTRUCTIONS FOR CISSELL MOIST-RITE CABINETS AND TUNNELS Forward - The Moist-Rite Finishing Cabinets and Finishing Tunnels are designed to restore the finish on most garments. It does an exceptional job on most wool, wool blends, synthetic blends, double and bonded knits and in general imparts a better finish on the quality garments. [. . . ] Connector Mixing Jet Tube (Water) Mixing Jet Tube (Steam) 1/4 Pipe x 3/8 Tube St. Connector Rear Boil Off Tube Return Tube Steam Coil Assembly w/deflectors Front Boil Off Tube 3/8" Angle Connector 3/8" Greenfield Cable 3/8" Straight Connector Junction Box Cover Junction Box Bushing 3/4 Lock Nut 3/4" Conduit 3/8 x 3/8 Elbow Solenoid Steam Valve 120V Strainer Nipple Assembly Mounting Bracket 1/2" All Thread Nipple 1/2 x 5 Pipe Nipple 1/2 x 1/4 Reducer 1/8 Pipe x 1/4 Tube Elbow 3/8 Connector w/Set Screw 1/2x3/8x1/2Tee Junction Box Cover Steam Tube Steam Supply Tube 1/4 Bulkhead Union 3/8 Bulkhead Union Short Return Tube Water Tube 1/8 Pipe x 1/4 Tube Elbow 1/8" Metering Valv Solenoid Valve (Condensate) Strainer Assembly Pipe Plug Air Deflector for Steam Coil Air Deflector for Steam Coil 3/8 Compression Bead 3/8 Compression Nut Elbow, 3/8 Pipe x 1/2 Flare Tube Condenser Water Tube Condenser Assembly Condenser Mounting Bracket Page 11 CONTROL PANEL ASSEMBLY SC876 - Control Panel - 120 V. , 60 Hz. SC877 - Control Panel - 240 V. , 50/60 Hz. Ref. [. . . ]