User manual CITIZEN WATCH B74

[. . . ] a b 50 5 1 LV. NG 0m 1 2 3 6 e 3 d . 2 LV DV 50 40 30 24 20 16 12 4 8 10 20 B 4 8 A 7 g f 10 9 0 12 15 7 60 45 30 15 40 6 c 5 30 30 20 20 40 IMPORTANT Before using When the watch does not operate according to the instruction manual, it is insufficiently charged. Charge the secondary battery of the watch for more than 4 hours, approximately 20cm (8in. ) away from the fluorescent or incandescent lamp (30W) as light sources. When charging the secondary battery, do not put it too close to the light source. * When charging the watch under direct rays of the sun, charge for more than an hour. This watch is an analog solar powered diver's watch into which an electronic depth meter function and chronograph function are built. [. . . ] · For pulling out the crown for adjustment, unscrew it to get it loose first. · After adjustment with the crown, press it in to the normal position and then screw it down without fail. · Do not operate any button while the crown is being pulled out. If a button is operated in such the status, it may cause some change in the indication or disorder of some hand(s). · Do not pull out or turn the crown when the watch gets wet or is in the water. Otherwise, the watch loses water-resistance and the inside of the watch gets wet. When the crown is screwed down (fastened). 9. DIVING MODE When the watch is immersed in the water, while it is set in the Time mode and the battery is charged enough for diving, the water sensor senses the water and switches the watch to Diving mode to measure the depth. In the Diving mode, the watch automatically memorizes the maximum depth of the last dive and the user can recall it after the dive. <Diving mode (Standby status)> Mode hand: "DV" position Hour hand 50 . 2 LV Function hand: * If the function hand and "0" position NG LV. 1 0m 3 6 10 20 30 9 DV 50 40 24 20 4 8 12 B 12 15 Minute hand 24-hour hand 40 16 7 60 45 30 15 A Date Second hand 30 mode hand don't point to their respectively specified positions (mode hand: "DV" position, function hand: "0" position) when the watch enters the Diving mode (standby status), adjust the hand positions referring to "11. MEASURES AGAINST POSSIBLE PROBLEMS". 36 20 37 <Depth indication> Indication range: 0 to 50 m (0 to 125 ft) deep (measured every second) Indication unit: 1 m/5 ft (Decimals of five and above in the first decimal place are rounded up and anything under five in the first decimal place is rounded down. Depth less than 1 m/5 ft is indicated as 0 m/0 ft. ) <Manner to read depth indication> When the watch reaches the depth of 1 m/5 ft or more in diving, it starts measuring the depth. In diving, the indication by the function hand represents the depth. · When the depth is less than 1 m/5 ft, the function hand indicates 0 m/0 ft. · When the depth exceeds 50 m (125 ft), the function hand stops at the overzone mark (52-seconds position) to show that the depth is out of the indication range. As the diver ascends in the water and the depth is less than 50 m (125 ft), the watch again indicates the depth. <How to cancel the Diving mode> (1) Press button A for 2 seconds after diving or in the water where it is less than 1 m (5 ft) deep (depth indication: 0 m/0 ft). The Diving mode is canceled and the watch returns to the Time mode. (2) When the watch is left for 10 minutes after diving or in the water where it is less than 1 m (5 ft) deep (depth indication: 0 m/0 ft), the watch automatically returns to the Time mode with cancellation of the Diving mode. If the watch is again immersed in the water 1 m (5 ft) or more deep within 10 minutes after the last dive, the new dive is regarded as a continuation of the last dive and the watch continues to measure depth. * Wet detection error indication If the diving standby mode (water sensor is in action) continues for 1 hour or more, the function hand points at the overzone mark. If the watch remains in this status for a long time, refer to "11. MEASURES AGAINST POSSIBLE PROBLEMS. " 38 39 <How to recall the memorized maximum depth> (1) Press button B in the Time mode or Diving mode 0m 3 6 (when depth indication is 0 m/0 ft). [. . . ] · Do not bring the watch close to a magnet or magnetic material. If the watch is brought close to a magnetic health appliance (magnetic necklace, magnetic bellyband, etc. ), the magnetic door of a refrigerator, the magnetic latch of a bag, the earphone of a cellular phone and so on, the watch may fail in keeping good time. If the watch is out of order for the said reason, keep the watch away from such things and reset the watch to the correct time. · The IC used in the quartz watch has a characteristic that it cannot withstand much static electricity. [. . . ]