User manual CITIZEN WATCH C660

[. . . ] 6 2 0 33 30 0 30 (A) 60 24 50 18 12 6 40 30 20 60 20 5 3 9 0 24 8 (C) 1 20 7 (B) 4 15 0 2 10 1 English Please charge the watch fully before use by exposing it to light. When the watch does not operate according to the instruction manual, it is insufficiently charged. Charge the watch for at least 3 hours approximately 20 cm (8 in) away from a fluorescent or incandescent lamp (30 W) as a light source. When charging, do not place the watch too close to the light source to prevent the watch from becoming too hot. [. . . ] After 24 hours have elapsed, the chronograph automatically returns to the chronograph reset display. <Normal Chronograph Display> (A) Press 24 50 18 12 6 40 30 20 60 20 <Chronograph Measurement> 1. Turn the crown to set the mode hand to the chronograph [CHR] mode. · The second hand rapidly advances to the 12 o'clock position and stops. Pressing button (A) repeatedly starts and stops the chronograph each time it is pressed. · When starting the chronograph, the second hand starts moving clockwise in conjunction. Split time is displayed for 10 seconds when button (B) is pressed during chronograph measurement. 18 6 40 20 12 30 (B) Press 30 31 · The `SPL" mark flashes in digital display-1 during split time display. In addition the second hand also stops moving. Pressing button (B) while the chronograph is stopped, returns the chronograph to the chronograph reset display. · The second and function hand (used as the minute hand for the chronograph) rapidly advance to and stops at the 12 o'clock position. Chronograph reset 24 50 18 12 6 40 60 20 (A) 20 (A) Measurement (B) Stops 30 *1 (B) *2 (A) Split time *1 (B) (A) *1: Returns automatically after timing for 24 hours *2: Returns automatically after 10 seconds 32 33 13. Using the Timer The timer can be set to a maximum of 99 minutes in 1 minute units. When the set time has elapsed, a tone indicating that the set time is up, sounds for about 5 seconds, after which the timer returns to the timer initial setting display. <Timer Initial Setting Display> <Timing using the Timer> 1. When pressing button (A) the timer starts counting (A) down from the time set. Pressing button (A) again during measurement 24 50 18 6 40 12 60 20 <Timer Initial Setting Display> <Setting the Timer> 1. Turn the crown to set the mode hand to the timer [TMR] mode. Pull out the crown to the first click (timer setting position) to enter the "minutes" correction state. · "Timer Setting Time (Minutes)" flashes in digital display-2. Turn the crown to set the "minutes" timer setting time. · When turning the crown to the right (clockwise), correction can be made in the positive direction. When turning the crown to the left (counter clockwise), correction can be made in the negative direction. After setting, return the crown to the normal position. 20 30 24 50 18 12 6 40 60 20 20 30 stops the timer and pressing button (A) once more while the timer is stopped, restarts the timer. · Pressing button (B) during timer measurement returns the watch to the timer initial setting display (B) and resumes countdown from the beginning. [. . . ] Water may enter the watch and compromise water-resistance. · If the watch is used in seawater, rinse with fresh water afterward and wipe with a dry cloth. 56 57 metal band. If your watch is not water-resistant, take it to your dealer. NOTE: Avoid using solvents (thinner, benzine, etc. ), as they may mar the finish. CAUTION: Operating environment · Use the watch within the operating-temperature range specified in the instruction manual. [. . . ]