User manual CITIZEN WATCH E67

[. . . ] Request to Customers All repairs performed on this watch, excluding repairs involving the band, are to be performed at the CITIZEN. When desiring to have your watch repaired or inspected, place contact the Citizen Service Center either directly or through the store where you purchased your watch. 3 RX: Reception standby NO: Reception result 24 hour hand NO Function hand (day, chronograph minutes, chronograph 1/20 seconds) H, M, L: Reception level/reception result Button (A) Minute hand Crown Date Button (B) Mode hand (time, chronograph, local time, reference position, alarm, date) W This watch is a radio wave watch that receives the standard time radio wave transmitted in Germany W This radio wave watch is equipped with a regular automatic reception function that sets the time and date by automatically receiving radio waves at 3:00 AM or 4:00 AM, and a free reception function that allows the time to be set arbitrarily at any time by receiving radio waves. · This watch is unable to receive radio waves of countries other than Germany. 60 RX TAC HY M L 70 ER ET Hour hand M 80 75 H 250 Second hand W Please use this watch after charging sufficiently by placing in light W If the second hand of the watch is moving at two-second intervals while the watch is in use, this indicates that the watch is insufficiently charged. Use the watch after first recharging by referring to the section entitled, "15. [. . . ] 41 70 ER ET M 80 75 40 18 0 250 ON 90 10. Manually Setting the Time and Daylight Savings Time · The time can be set manually when radio waves are unable to be received. · Daylight savings time is switched on or off automatically when radio waves have been received. Furthermore, remove the watch from your wrist before receiving radio waves to ensure that the time is set correctly. A. Setting the Time (The same time is displayed at the three locations of the TME mode. It is only necessary to set the time at one of these locations. ) [Normal Hand Movement] Crown at normal position 60 RX NO [Mode Correction] Crown at Position 1 60 RX NO [Time Correction] Crown at Position 2 60 RX NO TAC HY M L TAC HY M L TAC HY M L Button (A) H 10 0 OF F RADIO CONTROLLED 120 0 14 10 0 OF F RADIO CONTROLLED 120 0 14 Mode switching position 10 0 OF F RADIO CONTROLLED 120 0 14 Time correction Button position (B) <Time Correction Procedure> Pull the crown out to Position 1 and turn to align the mode hand to [TME] (time). (1) Pull the crown out to Position 2 (time correction position). · The second hand turns continuously and stops at the daylight savings time ON or OFF position. (2) Press button (B) for about 2 seconds. · When button (B) has been pressed for 2 seconds or more, the second hand advances (clockwise direction) to the 0 seconds position. Release your finger from button (B) once the second hand has stopped at the 0 seconds position. (3) Turn the crown to align the minute hand, hour hand and 24 hour hand at the current time. A Turning the crown to the right (by one click) causes the minute hand, hour hand and 24 hour hand to advance by one minute. B Turning the crown to the left (by one click) causes the minute hand, hour hand and 24 hour hand to go back by one minute. · Turning the crown continuously (rapidly by two clicks or more) causes the minute hand, hour hand and 24 hour hand to move continuously. · Turn the crown to the left or right to interrupt continuous movement of the hands. · Check AM and PM with the 24 hour hand to set the time correctly. (4) Return the crown to the normal position in synchronization with a telephone time signal or other time service. This completes the time correction procedure. 43 70 70 70 80 75 80 75 80 75 0 0 18 42 18 18 0 ER ET H ER ET ER ET M M M H 250 250 250 ON ON ON 90 90 90 B. Setting Daylight Savings Time <Procedure for Setting Daylight Savings Time> Perform the following steps while the time mode is already displayed. (1) Pull the crown out to Position 2 (time correction position). [. . . ] · Do NOT use the watch in places where it is exposed to high temperature, such as in a sauna. · Do NOT leave the watch in a place where it is exposed to high temperature, such as the glove compartment or dash-board of a car. Doing so may result in deterioration of the watch, such as deformation of plastic parts. · Do NOT place the watch close to a magnet. [. . . ]