User manual CITIZEN WATCH U040

[. . . ] Main Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Component Parts and their Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Switching Digital Functions (Modes) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . How to Call the Time or Calendar of Each City in the World . . . . . . . . . . [. . . ] The alarm is stopped by pressing any of the buttons. [Normal Alarm Display "ON"] Time difference from UTC (6) Press the button A to correct the "Minute. " (7) Press the button M to return to the normal display. * If the watch is set to 12-hour display of Time mode, Alarm will also be set to 12-hour display. * Auto-Return to normal Alarm display will be activated when the watch is left in Alarm correction state for about 2 minutes. * If the button M is pressed in the Alarm correction state, a quick return is made to the normal Alarm display. <To Switch Alarm On/OFF> When button A is pressed in normal Alarm display, "On" and "OF (OFF)" are changed each time the button is pressed. When Alarm is set to "On", "A1" or "A2" turns on in the digital display. <Alarm Monitor> Press and hold button A in Alarm mode to make the Alarm monitor sound. Alarm time M A B City name On or OF (OFF) <How to Set Alarm> (1) Press the button M to set Alarm 1 or Alarm 2 mode. (2) Press the button B to show a city whose alarm is to be set. (3) If the button B is pressed continuously for about 2 seconds, the alarm is turned On and "Hour" blinks. (4) Press the button A to correct the "Hour. " (Press and hold button A for rapid advancement. ) (5) Press the button B to blink the "Minute". 16 17 10. Using the Chronograph [CHR] This chronograph allows you to measure and display to maximum "23 hours 59 minutes 59 seconds 99" in units of 1/100 of a second. After the completion of 24hour measurement, it returns to the reset display and stops. It is also possible to measure split time (elapsing time). [Chronograph Reset Display] Time difference from UTC <Elapsed Time Measurement> (1) Press the button M to set the chronograph mode. (2) When the button A is pressed, it starts, and if the button A is pressed while measuring, it stops. Each time you press button A, start/stop is repeated. (3) If the button B is pressed while stopped, it returns to the reset display. <Split Time Measurement> Every time the button B is pressed during chronograph measuring, the newest split time is displayed for about 10 seconds. (2) Press the button B and show a city to be set. (3) If the button B is pressed continuously for about 2 seconds or longer, "On" or "OF" blinks. (4) Press the button A to select display (On) or non-display (OF) of the city. [. . . ] CAUTION Operating Environment · Use the watch within the operating-temperature range specified in the instruction manual. 31 CAUTION Keep Your Watch Clean · Leaving dust and dirt deposited between the case and crown may result in difficulty in pulling the crown out. Rotate the crown while in its normal position, from time to time, to loosen dust and dirt and then brush it off. · Dust and dirt tend to be deposited in gaps in the back of the case or band. Deposited dust and dirt may cause corrosion and soil your clothing. [. . . ]