User manual CITIZEN CBM-920

[. . . ] IMPACT DOT MATRIX PRINTER MODEL CBM-920 CBM-920 User's Manual Declaration of Conformity This printer conforms to the following Standards: Low Voltage Directive 73/23/EEC, 93/68/EEC and the EMC Directive 89/336/EEC, 92/31/EEC, 93/68/EEC. LVD : EN60950 Class A EMC : EN55022 EN61000-3-2 EN61000-3-3 EN55024 This declaration is applied only for 230V model. Warning: This is a Class A products. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. CITIZEN is a registered trade mark of CITIZEN WATCH CO. , LTD. , Japan CITIZEN es una marca registrada de CITIZEN WATCH CO. , LTD. , Japón CITIZEN CBM-920 User's Manual IMPORTANT SAFETY INSTRUCTIONS · · · · · · Read all of these instructions and save them for future reference. Follow all warnings and instructions marked on the product. [. . . ] (5) On replacing a ribbon cassette, pull it out as holding the "PULL" part. 16 CITIZEN CBM-920 User's Manual REMARK · In case the ribbon cassette is kept setting in printer so long time, there may be the case to make a paper dirty. And in case of continuous printing under low temperature, light print may be occurred due to the characteristic of the ink. Do not conduct printing with no ribbon cassette, this may damage a print head. Replace ribbon cassette before wearing out completely. Use exclusive ribbon cassette. · · · 4. 6 Setting Printing Paper (1) Open the front cover. (2) Cut the edge of Printing Paper as the following drawing. (3) Insert the paper into the paper insertion of the printer mechanism. When auto loading function is specified, paper is loaded automatically. When auto loading function is not specified, push the LF switch until the paper enters the printer mechanism. (4) By holding the paper holder in the arrowed direction, insert paper roll and make sure paper holder hold the core. 17 CITIZEN CBM-920 User's Manual (5) Eliminating slack on the printing paper, close the front panel. (6) To change paper, as holding the paper holder in the arrowed direction, re-move the core. Remove, at this time, excessive paper by using the LF switch. After setting the paper, press LF switch once. Then, printer goes to data input printing mode. REMARK · · · · Keep the paper winding direction correct. While in replacing of paper, do not send data from host terminal. Do not pull the paper in reverse direction of paper feed. T his may cause abnormality of print head. In case the paper is fed diagonally in paper supplying side or paper removing side, paper jam may occur. In this case, turn OFF the power switch immediately and pull out the excessive paper slowly at straight direction. 18 CITIZEN CBM-920 User's Manual 4. 7 Self-Printing Function (1) Test Printing By supplying power as pushing the LF switch, the characters for use, ROM version, DIP switch setting, and model name can be printed. After test printing, perform ordinary operation. By sending RESET signals as pushing the LF switch, perform test printing. During self printing, BUSY signal is being outputted. [. . . ] C1 = 0 (00H) : The upper bit is not used. C1 = other than 0 : The upper bit is used. Even if the upper bit is used, 0 is specified in this parameter, in case of double width and double height character, the highest dot is missing and proper print result may not be conducted. [Specifying address] A1 : Start of the registration address (20H ~ FFH) A2 : End of the registration address (20H ~ FFH) [Configuration of pattern data] The pattern data to be registered for one character is 9 byte. [. . . ]