User manual CITIZEN CBM230

[. . . ] User's Manual LINE THERMAL PRINTER MODEL CBM-230/231 Japan CBM Corporation Information Systems Div. CBM-230/231 User's Manual 1996. 08. 02(10-DCL)15 Declaration of Conformity Manufacturer's Name : Manufacturer's Address : Japan CBM Corporation : 1-1-7, Okubo, Shinjuku-ku, Tokyo 169, Japan Declare the Product Product Name Model Number (s) Thermal Printer CBM230 Series (CBM230R, CBM230P, CBM231R, BM231P (S. NO. 95Y0001 ) Conform to the following Standards LVD EMC : EN60950 : EN55022 : EN61000-3-2 : EN50082-1 : IEC801-2 : IEC801-3 : IEC801-4 :1992+A1+A2:1993 :1994 Class A :1995 :1992 :1991 4KV CD, 8KV AD :1984 3V/m, 27MHz-500MHz :1988 0. 5KV Signal Line 1KV AC mains Supplementary Information "The product complies with the requirements of the Low Voltage Directive 73/23/EEC, 93/68/EEC and the EMC Directive 89/336EEC, 92/31/EEC, 93/68EEC" Signature Place Date Tokyo, Japan November, 1995 Full Name : Koji Tanabe Position : General Manager R & D Department Europe Contact : Europe Liaison Office Kuruisweg 805, Holland Office Center Building 3-2132 NG Hoofddorp, the Netherlands Warning This is a Class A products. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. This declaration is applied only for 230V model. CITIZEN 2 CBM-230/231 User's Manual IMPORTANT SAFETY INSTERUCTIONS Read all of these instructions and save them for later reference. Follow all warnings and instructions marked on the product. [. . . ] The rightward space amount in double wide mode is made double of the set volume. CITIZEN 34 CBM-230/231 User's Manual (5) Specifying Collectively the Print Mode (ESC !n) Code: [1Bh] + [21h] + n * {0 < n < FF} The data is described in Hex code. Each n bit indicates the following: BIT FUNCTION 0 Font A VALUE 1 0 Character font Font B 1 Undefined 2 Undefined 3 Highlighting Canceled Specified 4 Double height Canceled Specified 5 Double width Canceled Specified 6 Undefined 7 Underline Canceled Specified l With double height and double width being specified simultaneously, double wide and double high characters are consisted. l An underline is attached to the full character width, which, however, is not attached to the part having been skipped by the horizontal tab. Neither is it attached to 90°-right-turned characters. l The underline width is as having been specified by ESC -. (6) Specifying/Canceling Download Character Set (ESC % n) Code: [1B]h + [25]h + n * {0 < n < FF} Data is described in Hex code. Specifying/canceling download characters. Download characters and download bit images cannot be defined simultaneously. Further, only the lowest bit (n0) is valid for n. The lowest bit (n0) indicates the following: n0= 0: Canceling download character n0= 1: Specifying download character CITIZEN 35 CBM-230/231 User's Manual (7) Defining Download Character (ESC & s n m a (D1D2 -Dn) Code: [1B]h + [26]h + s +n +m +a +Dn * {s = 02} {20 (Hex) n 7E (Hex)} {20 (Hex) m 7E (Hex)} {0 < a < 0A (Hex)} Defines the font of download characters of alphanumeric characters. l "s" indicates the number of bytes in vertical direction. l "n" indicates the start character code and "m" indicates the end character code. To define only one character, set n = m. l Character codes definable includes 95 ASCII codes in total between <20>H-<7E>H. l "a" indicates the number of dots in horizontal direction for definition. l Dn is the data to be defined, which indicate a pattern equal to "a" dot in horizontal direction from the left end. The rest of the pattern on the right side is filled with space. l Download characters thus defined remain valid until redefinition, ESC @ execution, GS * execution, or power OFF is practiced. CITIZEN 36 CBM-230/231 User's Manual Example For Font A CITIZEN 37 CBM-230/231 User's Manual For Font B CITIZEN 38 CBM-230/231 User's Manual (8) Specifying the Bit Image Mode (ESC * m n1 n2 D1 -Dn) Code : [1B]h + [2A]h + m + n1 + n2 + Dn * {m= bit image mode (See the table below. )} {0 n1 FF} {0 n2 02} Data is described in Hex code. According to the bit image mode assigned in m, prints data in the bit image. of dots printed is divided by 256, whose quotient is taken as n2 and residualas n1. of dots printed in the bit image is equal to n1 + (256 x n2). [. . . ] (41) Partial Cut (ESC m) Code : [1B]h + [6D]h Partial cutting of paper is carried out. l This is valid only when n is inputted at the beginning of line. CITIZEN 53 CBM-230/231 User's Manual 10 CHARACTER CODE TABLE 10. 1International CITIZEN 54 CBM-230/231 User's Manual 10. 2 International Character Code Table CITIZEN 55 CBM-230/231 User's Manual Appendix 1. Precaution and Maintenance 1. 1 Precaution for Handling the Printer Mechanism 1. Use of unspecified paper may not assure you of printing quality and product life. [. . . ]