User manual CITIZEN CT-S2000DCL

[. . . ] * The memory switches SW2-8 and SW4-8 will be ignored for label. CITIZEN is a registered trade mark of Citizen Holdings Co. , Japan CITIZEN es una marca registrada de Citizen Holdings Co. , Japón Company names and product names in this manual are trademarks or registered trademarks of relevant companies. Copyright c 2007 by CITIZEN SYSTEMS JAPAN CO. , LTD. 5. 4 Selecting Paper Type Paper type selection is available by the combination of memory switches SW4-4 and SW4-5 by the used of "Memory Switch Select Mode". In addtion, the following procedure is available. 1. 1 Features High-speed printing at a maximum of 220 mm/s is possible (* 154 mm/s at standard density on label paper). [. . . ] Since then, "P. Length Set" of Memory switch 4-1 becomes disable. When closing the printer cover during the setting a black mark paper or label paper in the printer, paper length is measured, and the result will be printed out. * When paper detection error occurs at the measurement of paper length, automatically enters paper sensor adjustment mode. Adjust the sensor in accordance with "5. 5 Adjusting the Sensitivity of Paper Sensor". Black Mark sensor(BM2) Black Mark sensor(BM3) 5. 5 Adjusting the Sensitivity of Paper Sensor Before using black mark paper (BM paper) or label paper, adjust the sensitivity of the paper sensor by using actual paper. Open the printer cover, remove paper, and then set the printer power switch to ON. Here, POWER LED and ERROR LED go on with the buzzer sound. Then close the printer cover while pressing the FEED button. The ERROR LED starts blinking with the buzzer sound. This printer has three types of built-in paper sensors. In case of label, set it so that label is positioned on the label light receiving sensor and label light emitting sensor. In case of black mark paper, set it so that the printable portion (other than black mark) is positioned on the black mark sensor. With this state kept, closing the printer cover causes ERROR LED to blink with the buzzer sound. 3 Adjust the sensitivity of the paper sensor and measure the length of paper. Pressing the FEED switch causes label to be fed and paper sensor sensitivity adjustment and paper length measurement are carried out automatically. If the FEED button is pressed during the paper measuring, the result will be printed out as follows, and the printer memory switch will be initialized. [. . . ] Adjusting the paper sensor must be carried when the type of liner is changed. PCS value of black mark must be 0. 9 or more. When using the black mark paper, consider the margin of +/- 2 mm for the print position against the standard position and +/- 5 mm for print length. [. . . ]