User manual CITIZEN CT-S601

[. . . ] En If you want to dispose of this product, do not mix it with general household waste. There is a separate collection systems for used electronics products in accordance with legislation under the WEEE Directive (Directive 2002/96/EC) and is effective only within European Union. This printer conforms to the following Standards: This declaration applies only to the 230-V model. IMPORTANT: This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may cause interference to radio communications. [. . . ] Place the AC power cord so that people do not trip on it. Ethernet and Powered USB interfaces are available as options in addition to those listed here. Always unplug the AC adapter from the printer before connecting the printer to a Powered USB interface. failure to do so may damage the host PC. For information about installing a Powered USB interface, contact your Citizen Systems dealer. When disconnecting the cable, always hold the connector. Be careful not to insert the USB interface cable into the cash drawer kick-out connector. To connect more than one printer to a single computer via a USB interface you must change the serial number of the USB interface. Use a serial interface cable with the connection layout shown below. Place the interface cable so people do not trip on it. Confirm the orientation of the cash drawer kick-out cable connector and connect it to the cash drawer kick-out connector at the back of the printer. Screw the cash drawer's ground wire to the body of the printer. Screw for ground wire Connect only the cash drawer kick-out cable connector to the cash drawer kick-out connector. ) Signals cannot be output from the cash drawer kick-out connector while printing. 1 2 3 4 5 6 Signal FG DRAWER1 DRSW VDR DRAWER2 GND Function Frame ground Cash drawer 1 drive signal Cash drawer switch input Cash drawer drive power supply Cash drawer 2 drive signal Signal ground (common ground on circuits) Connector used: TM5RJ3-66 (Hirose) or equivalent Applicable connector: TM3P-66P (Hirose) or equivalent 3 V (3) DRSW signal DRSW signal status can be tested with the DLE+EOT, GS+a, or GS+r command or at pin 34 on the parallel interface port. Cash drawer open/ close switch Cash drawer Printer Cash drawers 1 and 2 cannot be operated at the same time. The solenoid used for the cash drawer should be 24 or more. do not allow the electric current to exceed 1 A. Excessive current could damage or burn out the circuits. The printer can be used horizontally, vertically, or installed on a wall. However, the CT-S601S (built-in power supply type) cannot be used vertically or installed on a wall. Use the optional stand for vertical applications, and the optional brackets for wall installations. [. . . ] Press the FEED button twice and close the paper cover. (The current settings for memory switches 7 to 10 are not printed. The list of memory switches cycles through in order from "Memory SW (1)" "Memory SW (2)" . "Memory SW (10)" "Save To Memory" "Memory SW (1)" each time the FEED button is pressed. [. . . ]