User manual CITIZEN CT-S651

[. . . ] En If you want to dispose of this product, do not mix it with general household waste. There is a separate collection systems for used electronics products in accordance with legislation under the WEEE Directive (Directive 2002/96/EC) and is effective only within European Union. This printer conforms to the following Standards: This declaration applies only to the 230-V model. IMPORTANT: This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may cause interference to radio communications. [. . . ] The insulation on the AC power cord may melt and cause a fire or electric shock. If the printer is not going to be used for a long time, unplug the AC power cord from the electric outlet. Place the AC power cord so that people do not trip on it. Always unplug the AC adapter from the printer before connecting the printer to a Powered USB interface. failure to do so may damage the host PC. For information about installing a Powered USB interface, contact your Citizen Systems dealer. check the orientation of the Powered USB cable connector before connecting it. Insert it straight in so that the pins do not bend. When disconnecting the cable, always hold the connector. Be careful not to insert the USB interface cable into the cash drawer kick-out connector. To connect more than one printer to a single computer via a USB interface you must change the serial number of the USB interface. hold the connector of the Ethernet interface cable perpendicular and straight when connecting or disconnecting it. Doing it at an angle may cause the connector to misconnect. Use a serial interface cable with the connection layout shown below. Place the interface cable so people do not trip on it. Confirm the orientation of the cash drawer kick-out cable connector and connect it to the cash drawer kick-out connector at the back of the printer. Screw the cash drawer's ground wire to the body of the printer. Screw for ground wire Connect only the cash drawer kick-out cable connector to the cash drawer kick-out connector. ) Signals cannot be output from the cash drawer kick-out connector while printing. Hold the connector of the drawer kick cable perpendicular and straight when connecting or disconnecting it. Doing it at an angle may cause the connector to misconnect. 1 2 3 4 5 6 Signal FG DRAWER1 DRSW VDR DRAWER2 GND Function Frame ground Cash drawer 1 drive signal Cash drawer switch input Cash drawer drive power supply Cash drawer 2 drive signal Signal ground (common ground on circuits) Connector used: TM5RJ3-66 (Hirose) or equivalent Applicable connector: TM3P-66P (Hirose) or equivalent 3 V (3) DRSW signal DRSW signal status can be tested with the DLE+EOT, GS+a, or GS+r command or at pin 34 on the parallel interface port. [. . . ] The list of memory switches cycles through in order from "Memory SW (1)" "Memory SW (2)" . "Memory SW (10)" "Save To Memory" "Memory SW (1)" each time the FEED button is pressed. Press the FEED button until the number for the memory switch you want to change is printed. A setting for the memory switch is printed, through the cycle, each time the FEED button is pressed for at least two seconds. [. . . ]