User manual CITIZEN VC-470TIV

[. . . ] Radio Signal Reception . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Poor Reception Areas . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Display during Reception . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Confirming Reception Status . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press the lower right button (A) during measurement to return to the initial set time and start measurement again. Press the lower right button (A) while the timer is stopped to return to the initial set time. · Digital display 2 changes to RES. 4. When the time is up, END is displayed in digital display 2 and the time-up tone sounds for 5 seconds. · To stop the time-up tone, press button (A) or (B). · RES is displayed on digital display 2 and the timer returns to the initial set time. * Radio waves cannot be received during timer measurement. * The measurement continues even if the watch is switched to a different mode during measurement. * The time-up tone does not sound unless the crown is in the normal position. Button (B) Button (B) Measurement mark [Digital display 2] [Digital display 1] 56 57 W 17. Using the Chronograph (CHR) · The chronograph can display times up to 23 hours 59 minutes and 59. 99 seconds. · After it exceeds 24 hours, the chronograph returns automatically to the reset status. · While the chronograph is being operated, the display of digital display 2 changes as follows. (Reset) Button (B) (During measurement) <Using the chronograph> 1. · SET (show) or OFF (hide) flashes. · The initial settings are all SET (show). Press the lower right button (A) to select SET or OFF. · Press the lower right button (A) to switch between displaying SET and OFF, and then select the desired setting. · Turn the crown to set other cities. Press the crown back into its normal position. City name Button (B) Mode switching position Correction position Button (A) City Display (SET)/ Hide (OFF) Daylight saving time Set (ON)/ Canceled (OF) <"Daylight saving time" and "Show/hide city" settings> 1. Pull the crown out to position 1 and turn to align the mode hand with WT-S (world time set mode). Pull the crown out to position 2 to enter the world time correction status. · Digital display 2 goes off, digital display 1 enters the daylight saving time setting status for the city that is displayed, and ON or OF flashes. · The initial settings are all OF (canceled). [Digital display 1] 60 61 <Setting the desired time difference> · Any time difference can be set between the HOM city and the UTC time, in units of 15 minutes. [. . . ] · Do NOT operate the crown or button with wet fingers or when the watch is wet. Water may enter the watch and compromise water-resistance. · If the watch is used in seawater, rinse with fresh water afterward and wipe with a dry cloth. · If moisture has entered the watch, or if the inside of the crystal is fogged up and does not become clear within a day, immediately take the watch to your dealer or Citizen Service Center for repair. [. . . ]