User manual CLARION BD216

[. . . ] Owner's manual Mode d'emploi Manual de instrucciones 1. When the inside of the car is very cold and the player is used soon after switching on the heater, moisture may form on the disc or the optical parts of the player and proper playback may not be possible. If moisture forms on the disc, wipe it off with a soft cloth. If moisture forms on the optical parts of the player, do not use the player for about one hour and the condensation will disappear naturally to allow normal operation. [. . . ] To remove fingermarks and dust, use a soft cloth, and wipe in a straight line from the center of the compact disc to the circumference. No New discs may have some roughness around the edges. The unit may not work or the sound may skip if such discs are used. to remove roughness from the edge of the disc. Ball-point pen Roughness Do not use any solvents such as commercially available cleaners, anti-static spray, or thinner to clean compact discs. No Do not use compact discs that have large scratches, are misshapen, or cracked, etc. Use of such discs will cause misoperation or damage. No Do not expose compact discs to direct sunlight or any heat source. No Note: · Do not use commercially available CD protection sheets or discs equipped with stabilizers, etc. These may get caught in the internal mechanism and damage the disc. 6 BD216 6. DCP (Detachable Control Panel) The control panel can be detached to prevent theft. We recommend taking the DCP with you when leaving the car. CAUTION · The DCP can easily be damaged by shocks. After removing it, place it in a protective case and be careful not to drop it or subject it to strong shocks. · When the release button is pressed and the DCP is unlocked, the car's vibrations may cause it to fall. To prevent damage to the DCP, always store it in a protective case after detaching it. · The rear connector that connects the source unit and the DCP is an extremely important part. Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc. DCP Rear Panel Source Unit Front Removing the DCP 1. Press the DCP Release button 1. DCP release button E glis 3. Remove the DCP. DCP connector Source unit connector Note: · If the DCP is dirty, wipe off with a soft, dry cloth only. DCP Attaching the DCP 1. Insert the side of the DCP into the main unit. Insert the left side of the DCP into the main unit. CAUTION Do not insert the DCP from the left side. Doing so may damage it. DCP BD216 7 7. OPERATION Note: · Be sure to read this chapter referring to the front diagrams of chapter 2. CONTROLS on page 3 (unfold). Basic Operations CAUTION When this unit is turned on, starting and stopping the engine of a car with its volume raised to the maximum level may harm your hearing. Be careful about adjusting the volume. Adjusting the Treble 1) Press A-M button @ and select "TrE". 2) Turning the Rotary knob 2 clockwise emphasizes the treble; turning it counterclockwise attenuates the treble. * The factory default setting is "0". [. . . ] (No sound is produced. ) Cause Fuse is blown. Solution Replace with a fuse of the same amperage. If the fuse blows again, consult your store of purchase. Eject the compact disc before loading the new one. [. . . ]