User manual CLARION CDC655TZ INSTALLATION MANUAL

[. . . ] When both of them are CD, the address switch needs to be reset so that the address switch number is not the same for each. Eject button 2. Use the wing nut to hold in place the installation bracket with bolt to the installation bracket, which is attached to the unit. <Vertical Position> <Suspending Position> 4. Remove the separator of the cushion rubber that is attached to the installation bracket with bolt and install accordingly. [. . . ] in the player. Slide cap Digital optical fiber cable 1 23 4 Note: Only the provided screws and brackets should be used during installation. Using screws other than those specified will cause damage. 2 PRECAUTIONS 1. This unit does not operate independently. The unit must be used with a source unit that has a cable connection for CeNET wire bound (sold separately). G The pickup, the heart of a player, is built in deep behind the door. Do not leave this door open for extended periods to prevent dust adhering to the pickup. G When the inside of the car is very cold and the player is used soon after switching on the heater, dew may form on the disc or optical parts of the player and proper playback may not be possible. If dew forms on the disc, wipe it with a soft cloth. If dew forms on the optical parts of the player do not use the player for about one hour and the condensation will disappear naturally to allow normal operation. While the system is in play, do not plug or unplug the cables as this will cause damage. When it is connected to a center unit suitable for CD TEXT display, CD TEXT can be displayed. (When it is connected to a center unit without CD TEXT function, CD TEXT can not be displayed. ) 6. Do not expose the magazine to direct sunlight, the car heater or other sources of strong heat. Replace the CD magazine (CAA-355) with a new one if bent or otherwise damaged. Address switch · When the CeNET cable is connected, it must be inserted fully and securely. After connecting, fasten the cable using the cable holder or cable clamp. After connecting, fasten the cables with cable holders, etc. · When removing the digital optical fiber cable, rotate it to loosen it and pull it gently while holding the slide cap (a gray color part on the source unit). · Do not coil up the digital optical fiber cable with a radius of less than 1" (3 cm). With a radius of less than 1", the performance of the cable will be greatly impaired. Distorted magazine. "No Disc" sign appears when searching for discs. Noise, skipping Buy New Magazine CAA-355. 5 CD MAGAZINE Inserting the CD 1. Turn the magazine over onto its back, put your finger on the disc holder release knob and draw out the disc holder. Magazine Disc holder Disc inserted upside- Read the section on "Inserting The CD" carefully and reinsert the CD down. [. . . ] Never touch the surface. Cleaning G To remove fingermarks and dust, use a soft cloth and wipe in a straight line from the center of the compact disc to the circumference. G Do not use any solvents, such as commercially available cleaners, anti-static spray or thinner to clean compact discs. G After using special compact disc cleaner, let the compact disc dry off well before playing it. Due to improvements, the design and these specifications may be modified without prior notice. 2. 3. Close the flip down door. Note: · Never insert the magazine for 12-disc CD changer (CAA-122) into this unit because it can become stuck and impossible to remove. · When the unit is installed below the horizontal position (up to 15 degrees) the ejected magazine, when left in that position, will drop due to vibrations from the car. [. . . ]