User manual CLARION CJ981E

[. . . ] Owner's manual & Installation manual Mode d'emploi et manuel d'installation Bedienungs- & Installationsanleitung Manuale d'Istruzioni e d'Installazione Thank you for purchasing this Clarion product. Please read this owner's manual in its entirety before operating this equipment. After reading this manual, be sure to keep it in a handy place (e. g. , glove compartment). Check the contents of the enclosed warranty card and keep it carefully with this manual. English Français English Contents 1. [. . . ] · Do not set or use scale markers when using a CCD camera made by a company other than Clarion. Notes: · Different camera types produce different patterns of scale marker. Be sure to set the camera function (CAM TYPE) before setting the markers in this section (MARKER). · The markers are not designed to ensure safety by indicating the actual position of the bumper, the vehicle's width or the distance to the rear. Press the [FUNC] button and switch to "CAM" mode. 2. Use the [SELECT] (z) button to select the CAMERA1 image. Press the [MODE] button to switch to the "MARKER SELECT" menu. Each time the [MODE] button is pressed, the mode cycles through the modes in the order "CAM" "MARKER" . . . "CAM". Vehicle width (From bumper toward rear) MARKER SELECT P1 7m 5m 3m 1m Bumper position ICCD camera installation conditions (scale marker input conditions) Unit: mm Marker No. (Pattern) P1 P2 P3 P4 P5 P6 P7 Camera Install Height 2000 2250 2500 2750 3000 3250 3500 Vehicle Width 2500 2. Use the [SELECT] (z) button to select the CAMERA1 image. Press the [MODE] button to switch to the "MARKER" menu. Each time the [MODE] button is pressed, the mode cycles through the modes in the order "CAM" "MARKER" . . . Use the [z] or [w] button to select "ON". Press the [MODE] button to return to the "CAM" mode screen. 2300 2500 4. Use the [z] or [w] button to select the desired marker pattern. · When the [z] button is pressed, the marker pattern cycles in descending order, from P1 P7 P6 . . . · When the [w] button is pressed, the marker pattern cycles in ascending order, from P1 P2 P3 . . . 8 CJ-981E Adjusting the Bumper Position (MARKER ADJUST) MARKER SELECT English P1 MARKER SELECT P1 MARKER SELECT P7 MARKER SELECT P2 MARKER SELECT P6 MARKER SELECT P3 MARKER SELECT P1 MARKER SELECT P7 5. Press the [MODE] button to return to the "CAM" mode screen. The display position of the scale markers set on the screen can be adjusted to more closely match the actual position of the vehicle's bumper. Note: · Different camera types are equipped with different scale marker patterns. Be sure to set the "CAM TYPE" first, and only then set the marker adjust. Press the [FUNC] button and switch to the "CAM" mode screen. Press the [SELECT] (z) button and switch to the CAMERA1 image. [. . . ] For extra safety, firmly fasten the stand base in place using the self-tapping screws. (In this case, note that screw holes will be drilled into the attachment surface. ) Self-tapping screws (provided) English 5. Lift up the display unit while pressing down on the unlock knob to temporarily remove the display unit. While pressing down Lift up. 8. After about 24 hours, install the display unit and adjust its angle for ease of viewing. [. . . ]