User manual CLARION CMD4A

[. . . ] Owner's manual Mode d'emploi Manual de instrucciones Istruzioni per l'uso CMD4A WATERTIGHT MARINE AM/FM/CD MULTIMEDIA CONTROLLER COMBINÉ NAUTIQUE ÉTANCHE RADIO AM/FMLECTEUR CD MULTIMEDIA CONTROLADOR MULTIMEDIA MARINO DE AM/FM/DISCOS CD IMPERMEABLE UNITÀ DI CONTROLLO MULTIMEDIALE PER USO MARITTIMO AM/FM/CD IMPERMEABILE Thank you for purchasing this Clarion product. Please read this owner's manual in its entirety before operating this equipment. After reading this manual, be sure to keep it in a handy place (e. g. , glove compartment). Check the contents of the enclosed warranty card and keep it with this manual. [. . . ] Press the [MENU] button to return to the previous mode. Note: · You cannot set the clock when it is displayed with only the ignition on. If you drain or remove the boat's battery or take out this unit, the clock is reset. While setting the clock, if another button or operation is selected, the clock set mode is canceled. Adjusting the treble (Frequency) The factory default setting is "T-FRQ10K". (Adjustment 10 kHz/15 kHz) Adjusting the bass (Frequency) The factory default setting is "B-FRQ 60". Press the [MENU] button to switch to the menu mode. Press the [å] or [] button to select "TREB FRQ". Turn the [ROTARY] knob to select the frequency. Press the [MENU] button to return to the previous mode. Setting the loudness The factory default setting is "OFF". 1. Press the [MENU] button to switch to the menu mode. Press the [å] or [] button to select "BASS FRQ". Turn the [ROTARY] knob to select the frequency. Press the [MENU] button to return to the previous mode. 1. Press the [MENU] button to switch to the menu mode. Press the [å] or [] button to select "ALOUD". Turn the [ROTARY] knob to select "ON" or "OFF". Press the [MENU] button to return to the previous mode. 16 CMD4A Operations Common to Each Mode English Adjusting the non-fader The factory default setting is "NFVOL +6". (Adjustment range: ­6 to +6) Performing a system check This function verifies the devices hooked up through CeNET. Press the [MENU] button to switch to the menu mode. Press the [å] or [] button to select "SCHECK". Press and hold the [ENT] button for 1 second or longer to start the system check. CeNET connection configuration is automatically checked. [. . . ] Water droplets may form on the internal lens. CD CeNET The microprocessor has not stored the proper CeNET information. The CeNET cable is not connected properly. Perform a system check. See "Operations Common to Each Mode", performing a system check section. Ensure the CeNET cables are properly connected. CMD4A 25 9. [. . . ]