User manual CLARION DB185MP

[. . . ] Owner's manual Mode d'emploi Manual de instrucciones DB185MP CD/MP3/WMA RECEIVER AUTORADIO CD/MP3/WMA RECEPTOR CD/MP3/WMA This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Turn the [ROTARY] knob to adjust the balance of the rear and front speakers. The factory default setting is "CENTER" (center). (Adjustment range: FRONT12 to REAR12 (front 12 to rear 12)) Adjusting the non fader output volume You can adjust the volume output from the unit's non fader output terminal. Turning the [ROTARY] knob clockwise increases the output volume; turning it counterclockwise decreases the output volume. The factory default setting is "0". (Adjustment range: ­6 to +6) Note: · During SOUND adjustment mode, if no operation is performed for more than 10 seconds, this mode can be cancelled and return to previous mode. DB185MP 15 Radio Operations English Listening to the radio 1. Press the [SRC] button and select the radio mode. Press the [BND] button and select the radio band. Each time the button is pressed, the radio reception band changes in the following order: F1 (FM1) F2 (FM2) F3 (FM3) AM F1 (FM1). . . Press the [x] or [v] button to tune in the desired station. Quick tuning Press and hold the [x] or [v] button for 1 second or longer to tune in a station. Step tuning Press the [x] or [v] button to manually tune in a station. Recalling a preset station A total of 24 preset positions (6-FM1, 6-FM2, 6FM3, 6-AM) exists to store individual radio stations in memory. Press the corresponding [DIRECT] button to recall the stored radio frequency automatically. Press the [BND] button and select the desired band (FM or AM). Press the corresponding [DIRECT] button to recall the stored station. Note: · Press and hold one of the [DIRECT] buttons for 2 seconds or longer to store that station into preset memory. Tuning There are 3 types of tuning mode available, seek tuning, manual tuning and preset tuning. Seek tuning 1. Press the [BND] button and select the desired band (FM or AM). If "MANU" is lit in the display, press and hold the [BND] button for 1 second or longer. "MANU" in the display goes off and seek tuning is now available. Manual memory 1. Select the desired station with seek tuning or manual tuning. Press and hold one of the [DIRECT] buttons for 2 seconds or longer to store the current station into preset memory. 2. Press the [x] or [v] button to automatically seek a station. When the [v] button is pressed, the station is sought in the direction of higher frequencies; if the [x] button is pressed, the station is sought in the direction of lower frequencies. Auto store Auto store is a function for storing up to 6 stations that are automatically tuned in sequentially. If 6 receivable stations cannot be received, a previously stored station remains unoverwritten at the memory position. Press the [BND] button and select the desired band (FM or AM). Press and hold the [ ] button for 2 seconds or longer. [. . . ] restored by turning the power off and on again. (Speaker volume is reduced automatically when the speaker protection circuit operates). If the sound is muted again, consult our service department. MP3/WMA files are absent in Write MP3/WMA files onto the disc properly. [. . . ]