User manual CLARION DC625 INSTALLATION MANUAL

[. . . ] Store these lock-pins carefully so they can be used again if needed. Note : Reinstall these lock-pins when shipping the unit back for repair. 30° H: Horizontal 45: Slope ° 15 V: Vertical 1. PRECAUTIONS 5. Never clean the surface of your DC625 with chemical solvents, as they could damage the finish. If the car is parked for a long time in the sun during summer or in a cold location during winter, the temperature inside the car will reach extreme levels. [. . . ] OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. THIS PRODUCTION COMPLIES WITH DHHS RULES 21 CFR SUBCHAPTER J APPLICABLE AT DATE OF MANUFACTURE. 50 KAMITODA, TODA-SHI, SAITAMA-KEN, JAPAN. 1. Be sure to use the screws, etc. , included in the package for installation. Using other screws could damage the set. 2. Set the selectors on both side panels to the "H" Position when installing the set horizontally, to the "V" position when installing the set vertically. When installing at the angle of 45°, set the selectors to the center click position. The set may be damaged if the selectors are not set to the proper positions. ¡Vertical Position ¡Horizontal Position 8 Screws M5 × 8 W-SEMS H 45 V SERIAL No. 5. Unfasten the wing nut and remove the unit. 2. IDENTIFICATION OF PARTS 1 1 Installation selector levers 2 Eject button 6. Return the floor carpet to its original place. Use a knife to cut into the carpet where the bolt can be felt, and allow the bolt to protrude from the carpet. Press the eject button for ejecting the magazine. 3 Flip down door 4 C-BUS terminal (13 pin) 7. Align the unit with the bolts and secure it with the wing nuts. ¡Suspending Position 4 1 3 2 Flip Down Door (shown open) 3. WIRE CONNECTION 6. CD CHANGER SOURCE UNIT CAUTIONS · If the unit is played immediately after switching on the heater when the inside of the car is extremely cold, the discs and the pick up will fog up. If this hap pens, the unit may not work normally. (Condensation) Use a soft cloth to wipe the disc when it fogs up. The fog will naturally disappear in about one hour and thereafter the disc will work normally again. While the system is in play, do not plug or unplug the cables as this will cause damage. Do not expose the magazine to direct sunlight, the car heater or other sources of strong heat. 1. For safety reasons, install the magazine only when the car is stationary. To prevent accidents, it is best that the volume inside the car does not exceed that of the outside. Do not use abrasive pads, benzene, thinners or alcohol. For stubborn dirt, use a soft cloth, lightly moistened with (warm) water and wipe gently. 3. · At the recess end of the flip down door lies the built-in pick up which is the core part of the player. [. . . ] Driving on bumpy roads which cause severe vibration may cause the sound to skip. s EXTRACTING THE MAGAZINE 1. Note: Be sure you insert the disc holder evenly and at the same level as the magazine. Magazine Magazine 2. Press the eject button 2 and take out the magazine. 1. When the inside of the car is very cold and the player is used soon after switching on the heater, dew may form on the disc or the optical parts of the player and proper playback may not be possible. [. . . ]