User manual CLARION DRZ9255

[. . . ] Thank you for purchasing this Clarion product. Please read this owner's manual in its entirety before operating this equipment. After reading this manual, be sure to keep it in a handy place (e. Check the contents of the enclosed warranty card and keep it carefully with this manual. [. . . ] When you have finished the adjustment, press the [s] button to return to the screen in step 8. When you have finished the adjustment, press the [ ] button to return to the screen in step 6. Repeat steps 6 to 13 to adjust the filter of each speaker. These two modes can be used to make the following various sound adjustments for playing back music sources: The filter (high-pass filter and low-pass filter) frequency can be set for each speaker according to the characteristics of the speaker. Set the lower limit frequency to be played back mainly on that speaker on the high-pass filter (simply called "HPF" from here on), and set the upper limit frequency on the low-pass filter (simply called "LPF" from here on). The following figure shows the factory default settings for filter frequencies in the Multi mode. Frequency band played back mainly by HIGH (2 kHz onwards) Frequency band played back mainly by MID (500 Hz to 2 kHz) Frequency band played back mainly by LOW (80 kHz to 500 Hz) Frequency band played back mainly by SUB-W (to 80 kHz) Select the Standard mode or the Multi mode according to your speaker configuration. When the filter is set to "THROUGH", the setting for that filter is disabled, and all frequencies are played back. The filter frequency ranges that can be set vary according to the speaker. Note, however, that the frequencies are selected from the value (1/3 octave steps) currently set on this unit. The following filters can be set for each speaker: Effectiveness can be adjusted for each filter (HPF or LPF). "-12dB/oct" is more effective than "-6dB/oct" and "-18dB/oct" is much more effective. the factory default setting is "-12dB/oct". Try switching between "-6dB/oct", "-12dB/oct" and "18dB/oct " and select the setting that sounds most natural to you. This function allows you to adjust how much the output level is to be lowered. EQ (Parametric Equalizer) This function allows you to correct in detail all frequency levels by a smooth curve by correcting frequencies matched to the type of your car. This can be adjusted when the Equalizer mode is set to "P. This can be adjusted when the Audio mode is the Standard mode or the Multi mode. When you have finished the adjustment, press the [s] button to return to the screen in step 6. Repeat steps 6 to 9 to adjust each of the adjustment items. Try switching between "NOR" (forward phase) and "REV" (reverse phase) and select the setting that sounds most natural to you. GAbout the time alignment function This function allows you to adjust the speakers so that any listener in the car can obtain the same sound effect from the speakers. [. . . ] Nothing happens when buttons are pressed. Sound is bad directly after power is turned on. Eject the compact disc before loading the new one. Clean the compact disc with a soft cloth. [. . . ]