User manual CLARION DSH920S

[. . . ] Owner's manual Mode d'emploi Manual de instrucciones DSH920S SIRIUS SATELLITE RADIO RECEIVER RÉCEPTEUR RADIO SATELLITE SIRIUS SINTONIZADOR SIRIUS DE RECEPCIÓN RADIO VÍA SATÉLITE Thank you for purchasing this Clarion product. Please read this owner's manual in its entirety before operating this equipment. After reading this manual, be sure to keep it in a handy place (e. g. , glove compartment). Check the contents of the enclosed warranty card and keep it carefully with this manual. English Contents 1. [. . . ] SIRIUS OPERATION Selecting Sirius Radio modes Press the [SAT] button or the [FNC] (FUNC) button to select the Sirius mode. The Sirius indication lights entering the mode that was engaged when the unit was turned off last time. Notes: · The [SAT] button selects the Sirius mode directly. Some source unit does not have a [SAT] button. · The [FNC] (FUNC) button selects the external devices connected to the source unit in order, for example: Radio mode § DAB mode § Sirius mode § CD mode § CD changer mode § . . . In the main display, press and hold the [DISP] (D) button for 1 second or longer to cycle between the following display modes: Channel name § title § artist name § category name § text § channel name § . . . Notes: · The Operation status indication of the source unit displays the abbreviated channel name for 2 seconds when a station is selected before returning to the previous display mode. · Scrolling starts when the channel name or other text has been displayed for 2 seconds. When scrolling finishes, the first text display appears. To start scrolling again, press the [ADJ] button. · The [ADJ] button is described in the source unit instruction manual either as the [T] (TITLE) button or [A-M] button. This refers to the function of the button labeled "ADJ" on the source unit panel. English Selecting a band Press the [BND] button to select a band. Each press of the button changes the display as shown below. SR1 § SR2 § SR3 § SR1 . . . The currently received band is displayed in the function mode indication. Models without a function mode indication display the band name and channel number in the Operation status indication. or etc. Channel selection Channels are selected with the following buttons. · The [a] or [d] button · A [DIRECT] button · The [SCN] (SC) button · The [CAT] (RDM) button For details, see the following operation descriptions. Notes: The audio output is muted and other button operations are not accepted during channel selection. q Information displayed during reception The following information is displayed in the Operation status indication when Sirius Radio cannot be received normally. · UPDATING : when the receiver is turned on the first time or after a reset · ACQUIRING : when a channel is being tuned in (no signal is yet received) ("LINKING" is shown on an 8digit display) · INVALID CH : a channel without a broadcast has been selected ("INVLD CH" is shown on an 8digit display) · NO SIGN-UP : a channel not covered by your contract · ANTENNA : no antenna is connected or the antenna is defective) Tuning mode (T-MODE) There are two channel selection modes: seek mode and manual mode. q Seek tuning Only channels that can be received are selected while channels without broadcasts and channels not covered by the contract are automatically skipped. The receiver seeks the next available channel below or above the current channel. Press and hold the [a] or [d] button. Switching the display 1. Press the [DISP] (D) button to select the desired display. [. . . ] 1 piece 10 DSH920S Installation Example (Installing the unit under the driver's seat) English 1. Attach the mounting brackets 1 to the sides of the DSH920S using the screws 2 provided. Drill holes in the floor mat to match the positions of the holes in the mounting brackets 1. Insert the canoe clips 3 from the rear of the floor mat and install the DSH920S. There are three mounting holes on each side of the DSH920S. [. . . ]