User manual CLARION DVH940

[. . . ] Owner's manual Mode d'emploi Manual de instrucciones DVH940 5. 1CH SURROUND DECODER · DÉCODEUR SURROUND 5. 1 CANAUX · DECSCODIFICADOR DE 5. 1CH SURROUND · DVH940 Thank you for purchasing the Clarion product. Please read this owner's manual in its entirety before operating this equipment. After reading this manual, be sure to keep it in a handy place (e. g. , glove compartment). Check the contents of the enclosed warranty card and keep it carefully with this manual. [. . . ] Press the [a] or [d] button to change to the [P. EQ E] display. Press the [ENT] button to display the adjustment item. Press the [a] or [d] button to select [EFFECT], [SIGNAL], [SP-SEL], [BAND], [FREQ], [Q], [GAIN] or [SIGNAL]. EFFECT: P. EQ effect is turned on or off. · Initial setting is [OFF] SIGNAL: selects the adjustment signal. The normal setting is [ON+], but use the [ON-] setting when this provides a better effect for low frequency range. Press the [ADJ] button to return to the original mode. English 4. Turn the [ROTARY] knob clockwise or counterclockwise to adjust each value. Press the [ADJ] button to return to the original mode. Setting speaker filter frequency (FILTER) This function is used to set a filter frequency that suits the frequency characteristics of the used speakers. · The initial value of [FRONT HPF], [SRD HPF] is [THRGH] (no filter). · The initial value of [CENTER HPF], [SUB-W LPF] is [120 Hz] · A speaker that was turned off in the Section "Turning speakers on or off (SP-SEL)" is not displayed. Press and hold the [ADJ] button for 1 second or longer to enter adjust mode. Press the [a] or [d] button to change to the [FILTER E] display. Press the [ENT] button to display the adjustment item. 8 DVH940 Setting Acoustic Features English 4. Press the [a] or [d] button to select the speaker to adjust. · FRONT HPF: high pass filter for front speakers · CENTER HPF: high pass filter for the center speaker · SRD HPF: high pass filter for the rear (surround) speakers · SUB-W LPF: low pass filter for the subwoofer 5. Turn the [ROTARY] knob clockwise or counterclockwise to select the frequency. · In case of [FRONT HPF] and [SRD HPF], the frequency is 50 Hz, 80 Hz, 120 Hz and [THRGH] (no filter). · In case of [SUB-W LPF], [CENTER HPF] the frequency is 50 Hz, 80 Hz or 120 Hz. Press the [ADJ] button to return to the original mode. Adjusting speaker delay time (DELAY) The timing when the sound of each speaker reaches the listening position depends on speaker installation and the size of the car. Adjust the delay time of each speaker so that the sound of all speakers reach the listening position at the same time as the sound from the front speakers. · A speaker that was turned off in the Section "Turning speakers on or off (SP-SEL)" is not displayed. [. . . ] The cable clip can be used to secure up to two optical digital cables. · When disconnecting a optical digital cable, squeeze the tabs at the right and left sides of the connector, and pull gently. Note: · The optical digital cable should not be bent with a gentle arc radius of 1. 5 cm or less. If it is bent sharper than this, the performance of the cable will be greatly reduced and the cable may be damaged. [. . . ]