User manual CLARION DVH943

[. . . ] Keep the inside of the car clean and well ventilated. Never subject the DVH943 to strong shocks or open its case. Use a soft, dry cloth to wipe dirt off the DVH943. never use a hard cloth or thinner , alcohol , etc. [. . . ] Press and hold the [ADJ] button for 1 second or longer to enter adjust mode. When a sub woofer is used, set [ON+], [ON-] or [OFF]. The normal setting is [ON+], but use the [ON-] setting when this provides a better effect for low frequency range. Turn the [ROTARY] knob clockwise or counterclockwise to adjust each value. The timing when the sound of each speaker reaches the listening position depends on speaker installation and the size of the car. Adjust the delay time of each speaker so that the sound of all speakers reach the listening position at the same time as the sound from the front speakers. A speaker that was turned off in the Section "Turning speakers on or off (SP-SEL)" is not displayed. Press and hold the [ADJ] button for 1 second or longer to enter adjust mode. Use the built-in test tone function of the unit to adjust the speaker output level to the same level. A speaker that was turned off in the Section "Turning speakers on or off (SP-SEL)" is not displayed. Press and hold the [ADJ] button for 1 second or longer to enter adjust mode. This function is used to set a filter frequency that suits the frequency characteristics of the used speakers. A speaker that was turned off in the Section "Turning speakers on or off (SP-SEL)" is not displayed. Press and hold the [ADJ] button for 1 second or longer to enter adjust mode. This function compresses the dynamic range of Dolby Digital to maintain low level sounds such as actor conversation and suppress loud sound volumes. These functions are only available on Dolby Digital DVD discs. Press and hold the [ADJ] button for 1 second or longer to enter adjust mode. Turn the [ROTARY] knob clockwise or counterclockwise to select the value from [MAX], [STD] or [MIN]. MIN: the most compressed dynamic range mode that renders even low sounds easy to hear. CTR WIDTH (0 to 7): Selecting CTR WIDTH mode will adjust the localization of the centre channel between the centre speaker and the front speaker L/R. Distributing the centre channel sound to the right and left will increase the integrated sound field image, providing you with an natural spatial feeling of sound. setting to the value 0 will produce the centre sound with the centre speaker. [. . . ] Position the unit on the floor mat, then mark and open holes in the floor mat so they are aligned with the mounting bracket's holes. Press the accessory canoe clips from the underside upward through the mat and into the mounting bracket holes. Route the CeNET cable with plenty of extra room so that the connector will not become disconnected accidentally. Always turn the main [POWER] switch [OFF] before connecting or disconnecting digital fiberoptic cables. [. . . ]