User manual CLARION DXZ776 USB INSTALLATION GUIDE

[. . . ] Install the remove screw to the source unit (Figure 7). This set is exclusively for use in cars with a negative ground, 12 V power supply. Be sure to disconnect the battery "-" terminal before starting. [. . . ] : The screws with this mark are originally attached to the vehicle. Note 1: In some cases, the center panel may require some modification (trimming, filling, etc. Note 2: If a hook on the installation bracket interferes with the unit, bend and flatten it with a nipper or a similar tool. Notes: 1) Some car models require special mounting kits for proper installation. consult your Clarion dealer for details. 2) Fasten the front stopper securely to prevent the source unit from coming loose. * This part is not provided in some models. Be sure to turn the power off when wiring. Be particularly careful where you route the wires. Keep them well away from the engine, exhaust pipe, etc. If it is, replace the fuse with a new one with the same amperage rating as the original one. Do not let the battery side touch other metal parts. When the CeNET extension cable is pulled, hold the slide cap part and pull it towards you. When the CeNET extension cable is extended or branches, use extension cable CCA-520 (2. 6m), or Y-adapter CCA-519 (each of them is sold separately). Use the CeNET extension cable made by Clarion. When the main power supply fuse in the car is 15 A or less, purchase an automotive cable that can withstand 15 A and supply this unit with power directly from the battery to ensure that the unit will operate normally. Note that a fuse must be installed at a distance no longer than 30 cm from the cable battery terminal to prevent accidents. [. . . ] Use a soft, dry cloth to clean the case. never use hard cloth , thinner , benzen , alcohol , etc. For tough dirt, apply a little cold or warm water to a soft cloth and wipe off the dirt gentry. [. . . ]