User manual CLARION M255

[. . . ] When it is very cold in the boat and the unit is used soon after switching on the heater, the disc and the optical components may become fogged and not operate properly. Fogged optical components will naturally return to normal when the unit is left for about one hour after which it will operate normally. When the boat is underway in rough water the sound may skip as a result of intense vibrations and shock. Even in the event that trouble arises, never open the case, disassemble the unit, or lubricate the rotating parts. English This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Turning the [ROTARY] knob clockwise emphasizes the treble; turning it counterclockwise attenuates the treble. The factory default setting is "0". (Adjustment range: -7 to +7) Note: · Bass and Treble can only be adjusted when the "Zenhancer" is off. 8 M255 Basic Operations English Adjusting the balance 1. Press the [A-M] button and select "BAL". Turning the [ROTARY] knob clockwise emphasizes the sound from the right speaker; turning it counterclockwise emphasizes the sound from the left speaker. The factory default setting is "0". (Adjustment range: L13 to R13) Switching the clock display Press and hold the [BND] button, and then press the [DISP] button to switch between the operation mode and the clock display. Setting the clock 1. Press and hold the [BND] button, and then press the [DISP] button to display the clock display. Press and hold the [BND] button, and then press the [DISP] button for 2 seconds or longer. Press the [ ] or [ ] button to toggle HOUR and MINUTE selection. Then turn the [ROTARY ] knob clockwise to increase hour / minute or counterclockwise to decrease hour / minute. Press the [BND] button, then clock is set. Note: · If you select another operation mode while you are setting the clock, the clock setting operation will be canceled. · If you remove the vehicle's battery for a check or repair, the clock will reset, so you must set it again. Adjusting the fader 1. Press the [A-M] button and select "FAD". Turning the [ROTARY] knob clockwise emphasizes the sound from the front speakers; turning it counterclockwise emphasizes the sound from the rear speakers. The line-level outputs are used in conjunction with the rear speaker settings. The factory default setting is "0". (Adjustment range: F12 to R12) Turning the MAGNA BASS EX on/off The MAGNA BASS EX emphasizes deep bass to provide you with a dynamic sound. The factory default setting is off. Press and hold the [A-M] button for 2 seconds or longer to turn the MAGNA BASS EX and "M-B EX" in the display lights on or off. Turning the screen saver function on or off This unit is provided with the screen saver function. If the button operation is performed with the screen saver function on, the operation display corresponding to the button operation is shown for about 30 seconds and the display returns to the screen saver display. Press the [SS] button while keeping the [BND] button pressed, to turn the screen saver function on or off. M255 9 Radio Mode Operations English FM reception For enhanced FM performance the tuner includes signal actuated stereo control and multipath noise reduction circuits. Manual memory function 1. Press the [BND] button, to select a band you want to store in the memory. Press and hold one of the [DIRECT] buttons for 2 seconds or longer to store the current station into preset memory. Listening to the radio 1. Press the [FNC] button and select the radio mode. To select a preset band, press the [BND] button, then select one of the preset bands such as FM1, FM2, FM3 or AM. [. . . ] (No sound is produced) Cause Fuse is blown. Solution Replace with a fuse of the same amperage. If the fuse blows again, consult your store of purchase. Eject the compact disc before loading the new one. [. . . ]