User manual CLARION RK1

[. . . ] Model RK1 O Owner's Guide limited lifetime consumer warranty This Ungo Pro Security system is warranted against defects in material and workmanship. The main unit is covered by this limited lifetime warranty. This Limited Lifetime Warranty applies to Ungo Pro Security systems that have been installed by an authorized Ungo Pro Security dealer. This warranty is to the Original Purchaser ("Owner") and to the original vehicle in which it was installed into. [. . . ] The optional Starter Kill will be deactivated. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehicle with the climate control system. If interior heating or cooling is desired, the climate controls must be preset, and the fan blower must be set to the desired level prior to remote engine starting the vehicle. IMPORTANT!(1) This product is not for use in manual transmissions. (2) Never remotely start the vehicle with the key in the ignition. To remote engine start the vehicle: 1. Press the button twice within 3 seconds on the remote. The parking lights will flash to confirm that the vehicle will attempt to start. 3. Release the button as soon as the parking lights flash. (In gasoline vehicles, the engine will start 4 seconds after the parking lights flash. In diesel vehicles, the engine will start when the WAIT-TO-START indicator on the vehicle's dash goes out. ) 4. Once the vehicle has started, it will run for the pre-programmed period of time (either 12, 24, or 60 minutes - see Programming Options section of this guide) or until a shutdown input is triggered. 11 When you are ready to drive the vehicle: 1. Insert the ignition key and turn it to the RUN (not the START) position. Press the brake pedal. Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down. While the vehicle is running during remote engine start operation, the system will monitor the vehicle and will automatically shut down the engine if the system receives any of the following shut-down inputs: The brake pedal is pressed. The shutdown toggle switch is put into the OFF position. The pre-programmed run time (12, 24, or 60 minutes) has elapsed. Remote button is pressed twice in 3 seconds to start the vehicle. 12 take-over mode The Override take-over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the climate controls on. Before turning off the engine, press and release on the remote twice in 3 seconds (or press and release the optional momentary switch). The parking lights will flash for confirmation. Turn the ignition key to the OFF position. (The engine will stay running. ) The engine will run until the pre-programmed time elapses or a shut-down input is received. (See the previous remote engine start section for a complete list of shut-down inputs. ) NOTE: This feature will not work if the brake pedal is being pressed. short-run/turbo Short-run turbo mode keeps the engine running after arriving at you destination for a programmable period of 1, 3 , 5 or 10 minutes. This allows the system's timer to conveniently cool down the turbo after you have left the vehicle. Remove your foot from the brake pedal and leave the engine running. [. . . ] Power Door Lock Control: Your system is capable of controlling many types of power door lock systems; however, some door lock systems may require extra parts. Consult with your dealer to determine which type of locks your vehicle uses. If power locks are connected, the system can be programmed to lock the doors automatically 30 seconds after the ignition has been turned off. The system can also be programmed to lock the doors when the ignition is turned on and to unlock them when the ignition is turned off. [. . . ]