User manual CLARION VX709

[. . . ] Owner's manual & Installation manual Mode d'emploi et manuel d'installation Manual de instrucciones y de instalación VX709 2-DIN DVD MULTIMEDIA STATION WITH 7-inch TOUCH PANEL CONTROL STATION MULTIMEDIA DVD 2 DIN AVEC COMMANDE PAR ECRAN TACTILE 7 pouces EQUIPO DVD MULTIMEDIA 2-DIN CON PANEL DE CONTROL TÁCTIL DE 7 pulgadas CLARION PRODUCT REGISTRATION INFORMATION For USA and Canada only www. clarion. com Dear Customer: Congratulations on your purchase of a Clarion mobile electronic product. We are confident that you'll enjoy your Clarion experience. There are many benefits to registering your product. We invite you to visit our website at www. clarion. com to register your Clarion product. [. . . ] Receiving the Channel "0" will display your Radio ID (8-digits number). Note: · If the [XM] key is not displayed or the message "CHECK XM TUNER" is displayed, check the connection with the XM Satellite Radio Receiver. · The audio output is muted and other button operations are not accepted during channel selection. Switching the operation mode Usually, the system will operate in the Channel selection mode. You can switch this to the Category selection mode by the following operation. Touch the [CAT] key to switch to the Category selection mode. If you do not perform operation for 15 seconds, the system will automatically return to the Channel selection mode. · Touch the [Back] key to switch to the Channel selection mode within 15 seconds. Information displayed during reception The following information is displayed when the satellite radio cannot be received normally. · When a channel is being tuned in (no signal is yet received): "LOADING" · A channel without a broadcast has been selected: "CH UNAVAILABLE" · A channel not covered by your contract: "CH UNAUTHORIZED" · When a channel is out of air time: "OFF AIR" · When no signal is received: "NO SIGNAL" · When the XM antenna is not connected correctly : "CHECK ANTENNA" VX709 41 XM Satellite Radio Operations English Owner's manual Tuning in a station Only channels that can be received are selected. Channels without broadcasts and channels not covered by the contract will be skipped. · This operation works only in the Channel selection mode. The system displays the information on the previous or next available channel. Touch the [ ] (Enter) key within 5 seconds. The system will tune to the channel that the information is displayed. Note: · If you do not touch the [ ] (Enter) key within 5 seconds, the system will return to the previous display. · When the Direct function is set to "ON" from the Options screen, touching the [ ] (Enter) key is not required. The system will automatically receive the specified channel when 2 seconds passes. Recalling a preset station A total of 24 XM stations can be stored (8-XM1, 8-XM2, and 8-XM3). This allows you to store your favorite XM stations in memory for later recall. There are 2 ways available to recall a preset station. · This operation works only in the Channel selection mode. Touch the [Band] key to select the desired band (XM1, XM2, or XM3). Press the [R] or [F] button to recall the previous or next stored station. Touch the [List] key to display the Preset List screen. Touch the desired Band key to select the band. Touch the corresponding Preset key to recall the stored station. [. . . ] Do not let the battery side touch other metal parts. caution English INSTALLATION MANUAL 5. Connect the CeNET extension cable fully and securely until it locks. When the CeNET extension cable is pulled, hold the slide cap part and pull it towards you. (Figure 9) · When you want to extend the CeNET cable, use extension cable CCA-520 (2. 5 m) or CCA-521 (0. 6 m) (each of them is sold separately). [. . . ]