User manual CLASSE AUDIO CAV-75

[. . . ] 7 WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 WARRANTY REGISTRATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 -3- UNPACKING & SET-UP Your Classé CAV-75 multi-channel power amplifier is packed in high density, semi-rigid foam placed in a special cardboard box. [. . . ] CONNECT ALL INTERCONNECT CABLES BETWEEN THE ELECTRONICS BEFORE CONNECTING THE A. C. THIS WILL REDUCE THE POTENTIAL SHOCK HAZARD. SEE ALSO THE WARRANTY SECTION OF THIS OWNER'S MANUAL. NORMAL OPERATION: Input and output connectors for each channel are clearly grouped and marked on the back of the amplifier. (Units are preset at the factory for NORMAL. ) See fig. 3a, 3b for typical connections of the CAV-75. Use only high quality interconnect and loudspeaker cables, and make all connections tight. If the input plugs are loose, remove them and pinch down the ground leaves slightly with pliers. Observe correct phasing of the loudspeaker connections, and tighten. BRIDGED OPERATION: -5 - The six (6) channels of the CAV-75 are divided into three (3) groups. These groups can be operated and configured independently _ Channel-1 with Channel-2, Channel-3 with Channel-4, and Channel-5 with Channel-6. When in bridged mode, the inputs of CH-1, CH-3 and CH-5 are used respectively (as marked above the jacks). The unused inputs of CH-2, CH-4 and CH-6 are automatically disconnected when configured in bridged mode. The following steps should be performed to switch between NORMAL and BRIDGED modes. 1) Turn OFF the unit and remove all connections, including the AC linecord. 2) Remove top cover with the Allen key supplied. 3) Locate the input board(s) of channels to be switched. (see fig. 1 page 7) 4) Locate and set jumpers to the desired operation mode. (see fig. 2a, 2b page 8) 5) Replace and secure the top cover. Make sure the input and output connections are according to the operating mode. (see fig. 3a&3b page 9) Please read through the previous normal section for general notes on securing good connections, and safety tips. CAUTION: Please remember that the negative output connection of a bridged amplifier is NOT a ground. Do not use a "common ground" or switchbox set-up. Do not use with electronic crossovers which have a common ground. REMOTE CONTROL: (optional) With a simple connection from the receiver box to the remote jack at the back of the amplifier, (see Fig. 2 page 8) the power amplifier can be turned ON/OFF from a distance (or from another room). -6 - -7 - -8 - -9 - CLASSÉ CAV-75 LIMITED FACTORY WARRANTY (North America only). IMPORTANT: Warranty registration, and a copy of the ``Authorized Dealer Bill of Sale'' must be received at the Classé Audio factory (address: page 14) within thirty (30) days of purchase by the original retail purchaser in order to validate these warranty. [. . . ] 40 lbs. -13- WARRANTY REGISTRATION You must fill out and return the form below, along with a copy of the authorized dealer bill of sale, to the factory within thirty (30) days of purchase. This will allow us to provide expedient service, information regarding updates and new products, and validate the Classé warranty. CAV-75 SERIAL NUMBER______________________________________________________ PURCHASE DATE____________________________________________________________ AUTHORIZED DEALER________________________________________________________ PURCHASER'S NAME_________________________________________________________ STREET ADDRESS____________________________________________________________ CITY________________________________STATE/PROV. ____________________________ COUNTRY________________________ZIP/POSTAL CODE__________________________ I BECAME AWARE OF THIS PRODUCT BY:_____________________________________ (DEALER, MAGAZINE, FRIEND, ETC. ) SEND TO: CLASSÉ AUDIO INC. Product Registration 5070 François Cusson Lachine, Quebec, Canada H8T 1B3 -14- Notice to all Classé Product owners: Thank you component. [. . . ]