User manual CLASSE AUDIO SSP-30 MKII

[. . . ] SSP-30 MKII Preamplifier/Surround Sound Processor SSP-30 MKII Owner's Manual 2 IMPORTANT: SAFETY INFORMATION CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUCTIONS IN THIS OWNER'S MANUAL AND ALL THOSE MARKED ON THE UNIT. RETAIN THIS OWNER'S MANUAL FOR FUTURE REFERENCE. 1) Do not open the SSP-30 MKII for any reason, there are no user serviceable parts inside. An open unit, particularly if it is still connected to an AC source, presents a potentially lethal shock hazard. Refer all questions to authorized service personnel only. [. . . ] The > and < Scroll keys must be used. ) EX 7. 1 Press this key to listen to the Special 7. 1 Analog inputs. (The 7. 1 inputs cannot be accessed in the remote Zone. ) TAPE Press this key to Listen to tape through the Main output. This is also a useful key to use to Monitor the quality of a tape you are making. The Main Source continues to be the Source selected, so you can continue to Tape. Toggle this Key to switch between Tape and main Source. See Note in Setup regarding the Tape Loop. ZONE Press this key to access the Zone Access Mode. Immediately press either the \/ or /\ keys to decrease or increase the volume or the < or > key to Scroll back and forth through the Ten Sources. MUTE THIS KEY HAS TWO FUNCTIONS: Press this key to Mute the Main outputs. ALSO: After pressing the ZONE key use this key to Mute the Zone outputs. \/ VOLUME Press this key to decrease the volume of the Main outputs. The Main volume keys affect only the Main outputs. VOLUME /\ Press this key to increase the volume of the Main outputs. The Main volume keys affect only the Main outputs. . 16 Section 5. 0 - Setting Up the SSP-30 MKII The SSP-30 MKII has a complete and well-thought-out configuration system, flexible enough for even a complex audio and Home Theater system. You will find setup to be quite intuitive, and that once set up, operation of the SSP-30 MKII will prove to be simple and straightforward. Setup requires use of the supplied Classé remote control. You may use either the On-Screen (TV) menu or the illuminated front panel readout. The two methods are equally easy to use and understand. The same highlighted selection on the TV output is the visible on the panel. To Begin: be sure the SSP-30 MKII is on. (Press "Standby" if green light on the left is on). If the SSP-30 MKII is not on, and the green light is not lit, turn the unit "ON" with the rocker switch above the AC cord on the rear panel. [. . . ] Do not connect to REC. 6. 3. 4 6. 3. 5 6. 3. 5. 1 Follow the usual recording component instructions for recording. The digital output of the SSP-30 MKII's DIGITAL OUT always follows the input on the SOURCEs AV 1 through AUDIO 4. 26 6. 4 6. 4. 1 RECORDING DIGITAL AUDIO ONLY SSP D-VCR. Use a TOSlink cable to connect the output of the SSP-30 MKII's digital output to the digital input of the digital recording component. (If you are using one digital output for a Digital VCR you may use the other for the Digital Tape Machine). [. . . ]