User manual CLATRONIC AR 661 CD MP3 NEW

[. . . ] Autoradio con lettore CD Car radio with CD player Radio samochodowe z odtwarzaczem CD To avoid the risk of fire or an electric shock, you should not expose the device to rain or moisture. Consequently, do not use the device in the immediate vicinity of water - for example near a bath tub, a swimming pool or in a damp cellar. Use the device only for the intended purpose. When using external mains supply, pay attention to the correct polarity and voltage. [. . . ] Keep the I or I button pressed down in order to start searching for a radio station. If you would like to scroll the titles of the tracks keep the I or I arrow button pressed. Mode Button Press this button to select the CD player or radio mode. MUTE Button Press the MUTE button to switch off the loudspeakers for a short time. Press this button again to cancel this function. AP Button (Autostore - Automatic Station Storage) In radio mode: a) Memory function : Press the AP button for longer than one second to activate automatic station storage. FM 1, for the strongest signal level until the search cycle has finished. the six strongest stations are then allocated to the corresponding storage locations. The stations that have now been stored are played for approximately 5 seconds each and then the station of the first storage location is set. If you would like to search for more stations in the FM band, press the BAND button in order to change to the FM 2 or FM 3 band. Press the AP button again for more than one second in order to start the continued search. B) Scan Function: After the AP button has been pressed briefly the radio plays all the pre-set stations in the current frequency band for a short time. Note: The scan function ends automatically when it reaches the storage location from which it started. AP button as a search function during MP3 playback If the corresponding data were created when a CD was made in MP3 format, these can be searched for using the following functions: a) Direct input of the track number for CDs in MP3 format: 1. With the help of the +/- buttons it is now possible to put in a track number from 0 to 9 in the units place. Press the SEL button briefly once more to put in a hundreds place if necessary. Press the SEL button for 1 second to complete entry of the track numbers. Immediately after this the selected track is played. Using the +/- buttons it is now possible to select the various directories on the CD. The selected directory is played starting with the first song. Press the SEL button briefly and you can select a track in the directory using the +/- buttons. Immediately after this the selected track is played. [. . . ] pull out the CD in the direction of the arrow. Note: Do not use any solvents such as petrol or thinning agents. Inserting the CD If the CD is inserted with the printed side facing downwards, the device may be damaged. Always insert the CD with the label facing upwards. [. . . ]