User manual CLATRONIC BS 1230 NEW

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] Then assemble the floor nozzle (12) and/or the accessories. Insert the mains plug into a correctly installed safety socket (230 V, 50 Hz) and then switch the machine on using the on/off switch (2). Set the vacuum power with the vacuum power regulator (3). Attention: pay attention to the range that can be covered with the cable length. Vacuum power regulator: Low vacuum power: Medium vacuum power: High vacuum power: Cable winding device: Pull out the cable (1) up to the maximum length indicated with the yellow mark. Never pull the cable out up to the red mark as the cable winding can be damaged. Said damages are not covered by the warranty. Take out the nozzle you require: Nozzle accessories: Crevice nozzle/Brush nozzle: To vacuum corners and slits "2-in-1" nozzle: When this is folded together (as stored in the compartment) it can be used as a groove nozzle. If you would like to use the brush nozzle, pull the brush section in the direction of the arrow until it locks in place. upholstery nozzle: To clean upholstery , curtains , etc. Floor nozzle: To clean carpets or smooth surfaces. Releasing the accessories: Pull these off while turning slightly. Remove the bag holder, press the button with the spring together in order to release the bag and then pull the dust bag out of holder. Press the button again and fix a new bag in place. Re-insert the bag holder and then close the lid so that its locks in place. Clean the engine protection filter after 10 dust bag changes. If necessary, the filter can also be washed in warm water without any additives. Place it back into place only once it is completely dry!It is located on the rear part of your appliance behind a ventilation grid. open the ventilation grille by pressing the button above it. [. . . ] in such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]