User manual CLATRONIC ES 2573 2

[. . . ] Proceed as described in item 1 to 8 of "Making an Espresso" without using espresso coffee though. Fill the required amount of fresh clear water into the tank. Release the filter holder (10) by turning the handle to the left (INSERT). place the filter (12 or 13) into the filter holder (10). [. . . ] Distribute the coffee evenly and press the coffee powder lightly with a measuring spoon or other spoon. The aim of pressing the coffee powder with the spoon is to distribute it evenly in the coffee bowl rather than compressing it. In order to preheat your espresso cups, place them on the warming plate (2) above the percolating head. The control lamps (4+ 5) located on the right and left in the function control light up. Note: if the control lamp lights up again before percolation is finished, the water temperature is no longer high enough. Turn the function selection switch (3) to O and wait for the lamp to go out again. You can now continue preparing the espresso. Remove the espresso cup(s) from the warming plate (2) and place them under the percolating head. The espresso is now ready and is poured into the cup(s). When percolation is finished, turn the function switch (3) back to the O position. After brewing wait for a few seconds before removing the filter. After frothing milk, the steam nozzle is to be immediately cleaned from all milk residues. If the milk dries, it becomes difficult to remove. Soak the steam tube in a container with water over night so that the milk residue softens. Wipe the steam nozzle with a moist cloth to remove the milk residue before it hardens. The water tank, drip tray, drip tray cover, filter, filter holder and the hotplate can be washed by hand in a sink with warm water. If the filter's holes are clogged, clean it with a fine brush. Never wash the parts or accessories in a dishwasher. To empty the tray you can remove the drip tray completely and lift the grid. This appliance conforms with the CE directives for radio interference suppression and low-voltage safety and has been built to meet current safety requirements. Subject to technical changes without prior notice!The device supplied by our Company is covered by a 24 month warranty starting on the date of purchase (receipt). [. . . ] The device supplied by our Company is covered by a 24 month warranty starting on the date of purchase (receipt). During the life of the warranty any fault of the device or its accessories *) ascribable to material or manufacturing defects will be eliminated free of charge by repairing or, at our discretion, by replacing it. The warranty services do not entail an extension of the life of the warranty nor do they give rise to any right to a new warranty!Proof of the warranty is provided by the proof of purchase. [. . . ]