User manual CLATRONIC HSMR 2592 OTHER MANUAL

[. . . ] ⷠAlways remove the plug from the socket whenever the device is not in use, when attaching accessory parts, cleaning the device or whenever a disturbance occurs. ⷠIn order to protect children from the dangers of electrical appliances, never leave them unsupervised with the device. Consequently, when selecting the location for your device, do so in such a way that children do not have access to the device. Take care to ensure that the cable does not hang down. [. . . ] do not charge the machine in a humid atmosphere. When charging keep the machine AWAY from direct sunlight or sources of heat. Do not press the cutting head too much against the skin. NEVER use any adapter other than that supplied with the machine. Direct connection mode and battery mode The hair and beard cutting machine can be used either in direct connection mode with the adapter or in battery mode after being charged. For DIRECT CONNECTION MODE insert the plug of the adapter into a 230V/50Hz socket, insert the connection cable into the connection socket located on the hair clipper and place the function selector either on ON. When fully charged the device has a maximum operating life of 25 minutes. After this time it must be switched off and allowed to cool down for 25 minutes. The charging LED lights up during the charging procedure. Useful tips on battery life Battery life can be lengthened by paying attention to the following instructions: · Wait until the battery is almost completely flat before charging it. ⷠNever leave the machine connected to the charger for more than 24 hours. ⷠCharge the machine only with room temperatures between 0 and +40°C. Start with the longest cutting level and shorten the whole beard or the beard on the chin or cheeks gradually to the desired length. Note: Lock the selected cutting length (cutting length comb) in position with the locking switch located on the back of the housing (position 8 ­ , , lock"). Start with the longest cutting level and shorten the hair gradually to the desired length. Note: Lock the selected cutting length (cutting length comb) in position with the locking switch located on the back of the housing (position 8 ­ , , lock"). The shearing head enables the precise trimming of the beard contours even areas, which are difficult to reach, and the clean shaving of the hairline in the neck area. Use only a slightly humid and soft cloth to clean the machine. [. . . ] Should the warranty be valid, please consign the complete appliance in its original packing together with the cash receipt to your local dealer. You are not entitled to the replacement of the appliance owing to broken glass parts and faulty accessories. However, said parts will be replaced free of charge. In this case only the faulty accessory needs to be ordered without sending back the whole appliance! [. . . ]