User manual CLATRONIC KAC 2917 NEW 2

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] Putting the device into operation Wipe all the parts with a moist cloth to remove all the dust that may have deposited on and in the device during transport. Then mount the device again by proceeding in the opposite order. Carry out 2 or 3 cycles with cold water only to clean the device before brewing the first cup of coffee. The base of the coffee machine can also be mounted on a wall with the help of screws (not supplied). to do so , please measure the distance between the indentations on the rear. Beforehand you should ensure that you will not damage any pipe or electric wiring hidden in the wall!Check whether the electrical voltage that you intend to use is the same as that of the machine. Details are to be found on the label on the base. Now fill with enough fresh cold water for the desired number of cups. You can read the level on the water level display. Pull out the permanent filter and fill in some coffee powder. Then replace the permanent filter and place the coffee pot on the stand. Lock in the filter until it snaps into place. Your appliance is provided with a drip stop. By removing the pot, before the water runs through the filter completely, it avoids that the coffee drips on the base. If there is still water in the tank or filter, make sure that the pot is placed back under the filter to avoid overflowing. When the coffee stops flowing into the filter, you can remove the pot. In order to pour coffee out of the pot please turn the lid until the opening is opposite the handle. If you would like to stop using the kettle, first turn the on/off switch to 0 (off) and then remove the plug from the socket. Always pull he plug before cleaning and wait for the appliance to cool down. [. . . ] in such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]