User manual CLATRONIC MA 2640 NEW

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. [. . . ] Place the food to be cut on the carriage (3) and press it slightly in the direction of the knife using the press. Insert the mains plug into a correctly installed safety socket. Safety switch: This is used to set continuous operation. Press the safety switch (8) and keep it pressed. Press the safety switch (8) again and the cutting knife will stop. Apply slight pressure to the carriage so that it runs smoothly backwards and forwards. Just remove the latch to pull out the cutting board from under the device. In order to provide a stable support for the device's tray, pull out the metal frame (6) and insert the tray pan. Tip: If you wish to cut thick slices, moisten the blade slightly with a moist cloth. Scraps tray: This should be placed on the carriage in order to press the material to be cut. IMPORTANT: Do not use the device for more than 10 consecutive minutes. Leave the device to cool for at least 60 minutes before using it the next time. Revolution number setting (9): you can set the number of revolutions of the device by accelerating it or reducing the speed as you please. Clean the machine after use with a slightly damp cloth. The blade can be easily removed for cleaning. Proceed as follows: turn the blade lock clockwise (all you need is a coin) and remove the blade carefully with a glove. Please note that the housing screw (7) is not required to operate the machine. It is only used for servicing purposes and should only be opened by an authorised service technician. [. . . ] Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]