User manual CLATRONIC MC 1001 CD NEW

[. . . ] If the device is not used for a longer period, remove the plug connector from the plug socket or take out the batteries. These symbols may be found on the machine and are intended to indicate the following: The lightning symbol should advise the user of parts in the inside of the device which carry dangerously high voltage levels. The symbol with an exclamation mark should advise the user of important operation or maintenance instructions in the accompanying documentation. Devices bearing this symbol work with a , , class 1 laser" for tracing the CD. [. . . ] In order to set the minutes, proceed as before under point 4. Press the MEMORY/PROGRAM button when you would like to store your settings. Please note that the display only flashes for a few seconds in each case. If the adjustment is interrupted and the display is no longer flashing, adjustment of the time has to be started again from the beginning. Note: If the entire time display is flashing, this means that the stored time has been lost, possibly as a result of a power cut, and has to be set again. After each press of the button it is possible to read in the LCD display which function (CD, TAPE, AUXILIARY or TUNE) is activated. Use the SKIP/SEARCH buttons, I = forwards (7) and I = reverse (6) to tune into the desired radio station. if the appropriate button is pressed down for approx. 1/2 a second, the fast search is switched on. The stereo control lamp (16) lights up if you are receiving the station in stereo quality. If reception is too weak and there is interference on the station being received, this symbol does not appear in the display (16). Try to improve reception by turning, bending and altering the length of the aerial. In this frequency band all programmes are transmitted only in "mono". If you wish to store the selected station, first press the MEMORY/PROGRAM button (9 on the remote control). Now select the desired storage location using the M-UP/REPEAT button (10) on the remote control. When you wish to call up stored radio stations, press the PRESET button (8) on the music centre or the M-UP/REPEAT button (10) on the remote control. Push the function selector switch FUNCTION (13) until the word "TAPE" appears in the display. Insert an audiocassette into the compartment with the tape facing downwards and the side you wish to listen to facing forwards. If necessary, fast wind the tape forwards with the F. fWD button (23) or backwards with the REW button (22). When switching from one function to another, or when stopping the cassette, always press the STOP/EJECT button í (24). In order to interrupt playback for a short time, press the PAUSE button II (25). [. . . ] In this case, only the faulty accessory will be sent in or ordered with the agreement of our customer service!Damages to glass parts are not free of charge!Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]