User manual CLATRONIC MC 1003 CD NEW

[. . . ] If the device is not used for a longer period, remove the plug connector from the plug socket or take out the batteries. These symbols may be found on the machine and are intended to indicate the following: The lightning symbol should advise the user of parts in the inside of the device which carry dangerously high voltage levels. The symbol with an exclamation mark should advise the user of important operation or maintenance instructions in the accompanying documentation. Devices bearing this symbol work with a , , class 1 laser" for tracing the CD. [. . . ] Tune in on the desired broadcasting station with the Forward key (3) and the Backward (4) key. If the reception is weak and the received station rustles, this symbol does not appear on the display (27). Try to improve the reception by moving around and changing the length of the antenna. In this frequency band reception is possible only in MONO quality. To save the selected stations press first the MEMORY key (9 on the device) or PROG. /MEMORY (7 on the remote control) and then select the desired memory slot with the REPEAT/M-UP (6) key on the remote control. There are 40 available station keys (20 per band). Insert a recorded audiocassette with the tape facing down and the side to be played facing out. Press the Play key (14) to play the cassette. To wind the cassette forward or back use keys (16) and (15) respectively. Always press key Stop (17) when switching between or stopping cassette functions in order to avoid mechanical damages or damages to the tape. Press the key Stop (17) again to open the cassette deck (20). To briefly stop the playing, press the Pause key (18). Insert the audiocassette with the tape facing down and the side to be played facing out. Make sure that the cassette is protected against recording (the recording protection tongue on the top of the narrow side of the cassette must not be broken). Select the recording source with the function keys (6, 11 and 22) and start the source. Changes in the tone and volume do not affect the recording. The Play key is automatically pressed down as well. The recording can be briefly stopped with the Pause key (18) or stopped completely with the Stop key (17). Insert an audio CD with the printed side facing up and positioned the centering cone and close the CD deck. After a few seconds the display shows the total number of tracks and the total playing time. Press the Play/Pause key (2) to play the CD. [. . . ] *) Accessories are subject to the legally envisaged warranty obligation (6 months) and do not entitle to the free replacement of the entire device. In this case, only the faulty accessory will be sent in or ordered with the agreement of our customer service!Damages to glass parts are not free of charge!Defects to consumables or parts subject to wearing (e. [. . . ]