User manual CLIFFORD 58

[. . . ] Electronic Scan Prevention (ESP) -- ESP blocks electronic scanner codes to prevent disarming of your vehicle by anyone but you. Remote Panic with Safety LocksTM -- In a threatening situation, you can activate the siren, flash the parking lights and unlock the doors for immediate entry into your vehicle (requires optional relays). Interior Light Illumination Capability -- When remotely disarmed, the alarm system turns on the interior lights for 30 seconds or until the ignition key is turned on (requires an optional relay). Multi-Zone Protection -- Offers full perimeter security with separate trigger connections for the doors, hood and trunk (may require optional switches). 1 AMX58 Owner's Manual þ Previous Intrusion Alert -- Audibly warns you if the alarm was triggered while you were away. [. . . ] The siren will chirp twice, the parking lights will flash twice, the doors will lock, * the LED will flash slowly and the starter will be disabled. ** Passive Arming. Turn the ignition key off, exit the vehicle and close the doors. When the interior lights turn off, the LED will flash rapidly for 30 seconds to indicate the system is passive arming. The LED will then flash slowly to indicate the system is armed and the starter is disabled. (At any time during passive arming, you may actively arm the alarm. ) n n To Disarm the System -- Press remote button #1 for 1-2 seconds. The siren will chirp once, the parking lights will flash once, the doors will unlock, the interior lights will turn on (if the optional interior light illunination relay was installed), the LED will turn off and the starter will be enabled. * If your system was installed with the door lock/unlock fea ture, all other door lock/unlock related features will apply. ** If the optional starter disable was installed, all starter disable related features will apply. 3 AMX58 Owner's Manual n Remote-Controlled Silent Arm/Disarm -- Press remote buttons #1 and #2 at the same time. n Silent Arm Indications. The parking lights will flash twice, the doors will lock, the starter will be disabled* and the LED will flash slowly. The parking lights will flash once, the doors will unlock, the starter will be enabled and the LED will turn off. n n Interior Light Illumination Capability -- When the alarm system is remotely disarmed, the vehicle's interior light(s) will turn on for 30 seconds or until the ignition key is turned on (requires an optional relay). To Activate an Accessory -- Press remote button #2 for 1-2 seconds to activate an optional accessory such as trunk release, remote engine starter or a remote control garage door opener. Valet Switch -- The valet switch is a small hidden toggle switch which can only be controlled with the use of your ignition key. This switch allows you to program many features of the alarm system. In the event of a lost or stolen remote control, you can activate the Protected Valet Mode to bypass (shut off) the alarm functions. BE SURE TO ASK YOUR DEALER TO SHOW YOU WHERE THE VALET SWITCH IS LOCATED. n n n Protected Valet Mode -- You can place your system in Protected Valet Mode when your car is being serviced by mechanics, car wash personnel or driven by valet attendants, and still maintain possession of your remote control(s). While in Protected Valet Mode, all alarm functions are bypassed to prevent undesired or accidental arming. n To Turn on Protected Valet Mode 1. Turn your ignition key to the "ON" position or start the vehicle. Flick the valet switch to the "ON" position. The LED will turn on solid red to indicate the alarm is in Protected Valet Mode. 4 AMX58 Owner's Manual n To Turn off Protected Valet Mode 1. Turn your ignition key to the "ON" position or start the vehicle. Flick the valet switch to the "OFF" position, 3. The LED will turn off to indicate the alarm is no longer in Protected Valet Mode. n User Programmable Passive Door Lock -- The system will not automatically lock the doors when the alarm passively arms to prevent the keys and remote from accidentally being locked in the vehicle. If you prefer, you can easily program the systen to automatically lock the doors every time the alarm passively arms. See the "Programming Table for System Features" on page 8. [. . . ] Programming cannot be accessed while the system is in Protected Valet Mode indicated by the LED on solid red. Select the feature you wish to program from the "Programming Table for System Features" or the "Programming Table for Remote Controls" on pages 9 & 10. Note the number of chirps associated with that feature. Turn the ignition key to the "ON" position. [. . . ]