User manual CLIFFORD ARROW 3

[. . . ] United Kingdom customers: Please pardon our American English references and spellings. Trunk and hood references indicate the boot and bonnet, respectively; parking lights are indicator lights; gasoline is petrol. Standard Features The following are standard features of this system. Some vehicles may require optional parts/wiring and a few are incompatible with some features. þ EC-approved (Europe) Lifetime warranty (see terms & conditions) Two remote controls n Extended range n ACG 2TM Anti-CodeGrabbing protection n Low remote control battery warning þ Remote panic feature n Smart panic locking/unlocking based on whether the engine is þ on/off þ þ Built-in parking light flasher Courtesy light(s) turn on when you disarm with the remote (requires optional relay) Smart optional remote trunk release prevents falsing Smart AutoTesting self-diagnostics n With specific trigger & sensor identification þ þ PlainView 2TM coded valet mode n Select your own secret code þ þ þ Remote controlled valet mode Starter interrupt Piezo Sensor detects theft-related vibrations and impacts Smart DataPort input n For complete optional control of your system via your þ þ þ Malfunction AutoBypass n Automatic trigger remonitoring if trunk/hood was open when arming þ Smart Prior Intrusion Attempt Alert n With specific trigger & sensor identification þ Windows PC n For smart accessory interfacing þ TotalRecall 8-event trigger/sensor memory report n With specific trigger & sensor identification þ FACT anti-false alarm circuitry Passive AutoArming if you forget to arm with the remote control n Lock upon AutoArming self-locking n Visual AutoArming countdown confirmation n Instant AutoArm bypass þ Remote control code learning Clear all remotes if ever lost or stolen LED status indicator n Flash indications reveal status n Automatic battery saving mode þ þ þ þ High-Output Siren n Remote controlled chirp muting n Long-term selectable chirp muting n Remote siren silencing without disarming if falsely triggered þ þ Multiple vehicle control from the same remote control Multiple sensor/trigger inputs User-programmable features n SecureAccess coded programming n Programmable even while driving þ Power door lock control (some vehicles may require optional relays) Ignition-switch controlled AutoLocking/AutoUnlocking 2 þ þ NOTE: Your system MUST be installed by an Authorized Clifford Dealer in accordance with the in structions we sup ply them. The sys tem is intended for automobiles with a 12- volt battery and gasoline- or diesel-powered en gine. [. . . ] Ask your Authorized Clifford Dealer about the optional dual-zone (full alarm and light-impact warning tone) model of this sensor and other optional sensors that will further enhance the security of your vehicle, such as: n Glass Tampering Sensor: Today's thieves shatter vehicle windows with a small metal punch device that does not create any vibrations for an impact sensor to detect. The Glass Tampering Sensor detects the sound of glass breaking, and glass tampering attempts, and will trigger the alarm. into the passenger compartment, the primary zone of this sensor would trigger the full alarm. However, if a thief was lingering very close to your windows, a warning tone would sound. Since it can "see" through glass and canvas, this sensor is particularly well suited for use in convertibles and other open or soft-sided vehicles (targa, T-top and Jeep-like vehicles). conditions that falsely set off all other sensors. Even if you park on a hill, the Digital Tilt/Motion Sensor will accurately respond to the first hint of tampering to reliably protect your wheels and entire vehicle. n Digital Dual-Zone Proximity Sensor 4: Detects movement inside the passenger compartment and very near the vehicle. If a thief were to lean n Digital Tilt/Motion Sensor: Detects less than one degree of lifting or any minute motion of the vehicle while completely ignoring all other High-Output Siren n Remote siren silencing: If triggered by a non-threatening event, you can silence the siren without remotely disarming. Press button while the siren is sounding. Two chirps confirm that the sensor activated the alarm and the system is remaining armed. Four chirps confirm that the system is still armed, but that the ignition is on or the hood, trunk or a door is open and that this may indeed be a genuine theft attempt. n Automatic noise abatement: Alarm sounding is limited to five siren duration cycles even if a door is left open in the wake of an intrusion. n Long-term chirp silencing: You may silence the arm and disarm chirps on a long-term basis until you decide to restore them. Your vehicle's parking light flashes will continue to provide visual confirmation of remote controlled system arming and disarming. the programming procedure or via the CliffNet Wizard software. See User-selectable features. n Selectable siren duration (non-European models only*): You may change the factory set 30-second siren duration to 60 or 90 seconds via n Personalized Siren Sounds (requires the Self-Powered SmartSiren 4 option) (non-European models only*): The optional Self-Powered SmartSiren 4 sounds six different alarm sounds. You may turn any of the six sounds on or off via User-selectable features programming to create a different combination of sound patterns. So if you hear a siren at a distance, you will know for sure whether it is your car or someone else's. See User-selectable features (column 1, row 2). What's more, with the optional CliffNet Wizard software and DataPort Replicator Cable, you may select up to six sounds from more than a dozen different siren sound choices for truly unique customization. n Choose when your Personalized Siren Sounds* play: You may choose to have your Personalized Siren Sounds "play" every time the alarm is set off, or you may set the system to sound them only upon trigger activation. When set to "trigger only" the basic siren wail will sound if a sensor is activated, but the Personalized Siren Sounds will play if the hood, trunk or a door is opened. See User-selectable features (column 1, row 3). *Not available on European models in compliance with EC95/56 6 Smart AutoTestingTM Each time you remotely arm the system, it tests all triggers and sensors. If the hood or trunk is open, the system will immediately sound 4 chirps and 4 indicator light flashes instead of the usual 2 and 2. [. . . ] You must now add new/existing remotes with the "Add new remote control" feature and/or the "Other vehicle`s remote" feature. NOTE 4: Immediately PRESS THE BLANK BUTTON, THEN enter your new code, wait for the two chirps, then turn off the ignition (you'll hear 3 chirps to confirm program mode exit). You MUST now turn the ignition back on and then re-enter your new code. If the LED flashes on, your new code has been accepted. [. . . ]