User manual CLIFFORD BULLET

[. . . ] 11 To Erase Unwanted Remote Control Codes . 11 1 Standard Features q FACTTM -- False Alarm Control and Test -- eliminates recurring false alarms q Lifetime Warranty q $3, OOO Theft Protection Guarantee (see guarantee card for details) q A pair of PremierTM 4-Button/8-Channel Remote Controls with more than 4 billion digital codes q AntiScanTM -- blocks electronic scanners from disarming the alarm q Multiple-Car Control -- allows you to command several alarms with the same remote q MultiRemoteTM Recognition -- useful for other drivers, since the system will ac- cept up to 4 Clifford remote controls of any types or codes q Smart Trunk Release Capability -- electronic interlock ensures that the trunk can be remotely opened only when the alarm is disarmed q Remote Headlight Activation Capability -- illuminates your way safely to or from your car q Remote Window and Sunroof Closure Capability* -- remotely close the windows q SoftChirpsTM -- select from soft or full volume arm/disarm chirping q Triple-Mode Chirp Silencing Long-Term Chirp Silencing One-Cycle Chirp Muting Remote Controlled Chirp Muting q SmartDoorsTM Remote Door Locking/Unlocking -- lock/unlock the car doors with the remote control AutoLockTM -- automatically locks the doors when the engine is started AutoUnLockTM -- automatically unlocks the doors when the ignition is turned "off" Keyless Entry in Valet Mode -- allows for remote door locking/unlocking even in valet mode q Built-In Parking Light Flasher -- visually confirms alarm status from a distance q Headlight Reminder When Ignition is Turned Off -- you'll never again leave the headlights on q Smart AutoTestingTM -- automatically tests for any malfunction q Malfunction AutoBypassTM -- will advise you of any malfunction, then bypasses it q TotalRecallTM -- stores identity of any trigger or sensor activated q Enhanced AutoArmingTM AutoArming Enable/Disable -- allows you to enable or disable AutoArming any time Visual Parking Light Acknowledgment -- visually confirms AutoArming User-Selectable AutoArm & Lock -- allows you to select whether the doors will lock when the system is automatically armed q Dual-Level Tampering Warnings -- for maximum protection and minimum nuisance q Smart Prior Intrusion Attempt Alert -- identifies attempted intrusion point q High-Output Six-Sound Siren -- 125dB siren with six different alarm sound patterns q Fault-Proof Starter Interrupt -- immobilizes the vehicle while the system is armed q LED Status Indicator -- provides visual confirmation of alarm status q Magnetic Resonance SensorTM -- the best vibration/impact sensor q Remote Panic Feature -- for your own personal safety even away from the car q Hood/Trunk Trigger Input -- to provide total perimeter protection q Secured Valet Mode -- bypass alarm when car is valet parked or serviced *On various models of BMW, Jaguar, Mercedes Benz and Volkswagen. 2 Using Your Bullet Security System PremierTM 4-Button/8-Channel Remote Controls The Premier 4-button/8-channel remote control is a miniature radio transmitter with a range of up to 100 feet. Obstructions, interference or a weak battery will reduce the range. Your remote control is the key to your security system. [. . . ] The LED will turn off to indicate that the alarm is in normal operating mode. Keyless Entry in Valet Mode: Even if valet mode "on", you will still be able to remotely control all the convenience features. For instance, simply press button I as if you were arming or disarming and your car's doors will lock or unlock. You can also use buttons II and IV to activate other options. Enhanced AutoArmingTM If you forget to remotely arm the system, it will arm itself automatically ("passively") 30 seconds after the vehicle doors are closed. If you re-open any door(s) within the 30-second countdown, AutoArming will restart from the beginning once all doors are closed. This ensures you'll never accidentally leave your vehicle unprotected. Bullet includes all these Enhanced AutoArming features: AutoArming Enable/Disable: If you prefer, you may deactivate or reactivate AutoArming. To do, see User-Selectable Features on pages 9-10. Visual Acknowledgment: Five seconds after you exit the vehicle and close all the doors, the parking lights will flash twice to confirm that the AutoArming countdown is progressing. Then, 25 seconds later, the system will AutoArm. AutoArm & Lock: To ensure you can't accidentally lock your keys inside the car, the system is factory-set not to lock the doors upon AutoArming. To change this setting, see User-Selectable Features on pages 9-10. NOTE: To prevent AutoArming of the system when fueling the vehicle, either enable valet mode or leave one of the doors open (the system AutoArms 30 seconds after all doors are closed). 5 Smart AutoTestingTM Each time you remotely arm your vehicle, it will perform a series of tests on all triggers and sensors. If a trigger malfunction is found, you will be visually and audibly alerted immediately with 4 chirps and flashes instead of the usual 2. Before sounding the siren a second time, the system automatically checks for another activated trigger. Should the siren sound again, you will know for sure that someone is tampering with your vehicle. (To disable FACT, see User-Selectable Features on pages 9-10. ) Dual-Mode Tampering Warning Normally, the system immediately sounds its six-sound siren at the first inkling of an intrusion attempt. However, you may set the system to issue a rapid five-chirp warning whenever the system detects tampering to the exterior of your vehicle. If there is any further tampering within the next 30 seconds, or if a door, the hood or trunk is opened at any time, your system will sound a continuous 125dB six-sound siren blast. To select the mode of your choice, see User-Selectable Features on pages 9-10. NOTE:Turning on the Tampering Warning feature overrides the FACT feature, and vice-versa. Smart Prior Intrusion Attempt Alert When you remotely disarm, if you hear 3 chirps instead of the usual one chirp it means that a trigger or sensor was activated in your absence. When you enter the vehicle, the LED will blink several times, pause, then repeat the blink cycle 4 more times. Count the number of blinks in one cycle and refer to the chart below: Number of LED blinks per cycle after disarming 1 blink 2 blinks 3 blinks Trigger/Sensor Activated Magnetic Resonance Sensor Door trigger Trunk or hood trigger AutoLock/AutoUnLock For your safety and that of your passengers, the system automatically locks the doors when you turn on the ignition switch to start the engine and unlocks them once the ignition is turned off. If you prefer, you may turn off the AutoLock/AutoUnLock feature. [. . . ] Repeat steps 1-5 for any other features you wish to program. Programming Table for User-Selectable Features Feature # of Factory flicks & setting chirps ON 4 Secondary action Program completion confirmation 1 chirp 3 seconds after last step 1 chirp 3 seconds after last step 1 chirp 3 seconds after last step 1 chirp 3 seconds after last step 1 chirp 3 seconds after last step 1 chirp 3 seconds after last step Result User-Selectable Features AutoArming AutoArm & Lock Arm/Disarm Chirp Confirmation Chirp Volume Headlights On Reminder AutoLock/ AutoUnLock -- Change state from ON to OFF or vice-versa Change state from ON to OFF or vice-versa Change state from ON to OFF or vice-versa Changes state from LOUD to SOFT volume or vice-versa Change state from ON to OFF or vice-versa Change state from ON to OFF or vice-versa OFF 5 -- ON Full Volume ON 6 -- 7 -- 8 -- ON 9 -- 9 Feature Siren Duration Tampering Warning FACT -- False Alarm Control and Test Add a New Remote to Channel 1 (arm/disarm) Add a New Remote to Channel 2 (optional remote accessory) Add a New Remote to Channel 3 (silent arm/disarm) Add a New Remote to Channel 4 (optional remote accessory) Built-In Timer D # of Factory flicks & setting chirps 30 sec. 10 Secondary action Program completion confirmation Result -- 1 chirp 3 Change duration from 30 seconds after to 60 seconds or vice-versa last step 1 chirp 3 seconds after last step 1 chirp 3 seconds after last tap Change state from OFF to ON or vice-versa OFF 11 -- ON 12 -- Change state from OFF to ON or vice-versa -- 13 Press remote control button I (switch UP) 1 chirp Button I/channel 1 code of new remote control has been memorized -- 14 Press remote control button II (switch UP) 2 chirps Button II/channel 2 code of new remote control has been memorized -- 15 Press remote control buttons III (switch UP) 3 chirps Button I+2/channel 3 code of new remote control has been memorized -- 16 Press remote control button IV (switch UP) 4 chirps Button I/channel 4 code of new remote control has been memorized 30 sec. 17 3 seconds later, 1 chirp will indicate that the timer has started. When the desired interval has passed, turn off the ignition key. -- Set to any interval between 1 second and 2. 5 minutes D WARNING: If your built-in timer controls window/sunroof closure in your car DO NOT change the timer setting! [. . . ]