User manual CLIFFORD INTELLISTART 4

[. . . ] · NEVER remotely start or use ShortStop with a person or pet in the vehicle. · NEVER start if someone is behind or in front of the vehicle. UK residents: Please pardon our American English. [. . . ] Disarm, enter, but don't touch the brake or transmission. Insert your key and turn the ignition switch all the way on. ShortStop When you stop for a brief errand, rather than shut down and then restart the engine moments later, you may remove your car keys and remotely arm without shutting down the engine: 1. Park, place the transmission in park or neutral and engage the handbrake. Without touching the brake, press button 4 (master) or button D (companion). Two parking light flashes will confirm this action. Turn the ignition off and remove your keys. The engine will continue to idle under the control of your system for up to 30 minutes (can be adjusted to 5-60 minutes by your Authorized Clifford Dealer). When you return, use the To drive the vehicle after remote starting procedure noted above. LowTemp/LowBattery AutoStart Your system can be set to automatically start the engine if: · The temperature drops below a certain level and/or · The vehicle battery voltage drops below a certain level If the LowTemp AutoStart feature has been programmed on and remotely activated as noted in the system's complete owner's manual, the system will automatically start and idle the engine when the interior temperature drops to -15°C or lower. If the LowBattery AutoStart feature has been programmed on and remotely activated as noted in the system's complete owner's manual, the system will automatically start and idle the engine if the voltage drops below 12. 2 volts to recharge the battery. See your Clifford G4 system's Complete Owner's Manual (downloadable from www. clifford. com/register) for details on programming and remote activating feature. 3 Manual transmission SafeStart PLEASE NOTE: This section is only for vehicles with a manual transmission. For safety reasons, the transmission must be left in neutral if the engine will be remotely started. To assure safe remote starting, you must perform these steps before exiting: 1. Park and, while the engine is running, place the transmission in neutral and set the handbrake. Without touching the brake, transmit channel 11 (LevelShift button twice, then button 3) on the master remote or the button combination on the other remote assigned by your Authorized Clifford Dealer. Two parking light flashes will confirm this action. Turn the ignition off and remove your keys. This prepares the system to later accept your remote starting command. NOTE: For safety reasons, the system ignores the remote start command if the alarm sounded while you were away. [. . . ] Any damage to the product(s) as a result of mis use, abuse, ne glect, ac ci dent, in cor rect wir ing, im proper in stal la tion, de struc tion or alteration of the serial number, repair or alteration outside our factory, or any use violative of instructions furnished by us will void the warranty. This warranty is limited to defective parts and specifically excludes any incidental or consequential damages connected therewith. Clifford Electronics makes no warranty against theft. [. . . ]