User manual CLIFFORD INTELLIVOICE 4

[. . . ] IntelliVoice 4 Operation Instructions C ongratulations on your purchase of the Clifford IntelliVoice 4, a G4 system accessory. Your Clifford G4 vehicle security system is IntelliVoice 4 ready and will automatically provide the following human voice synthesis features. Arming When you arm your Clifford G4 vehicle security system with its remote control, IntelliVoice 4 will announce "ARMED" instead of the usual siren double-chirp confirmation. Disarming When you remotely disarm, IntelliVoice 4 will announce "DISARMED" instead of the usual single-chirp confirmation. [. . . ] Chime upon remote arming If the door-bell-like chime sounds immediately after you arm, IntelliVoice 4 is warning you that the hood or trunk is open. If the chime sounds 5-10 seconds after the "ARMED" acknowledgment, a sensor is active. Verbal diagnostic If you receive the chime upon arming, disarm, enter the vehicle and turn on the ignition. IntelliVoice 4 will verbally name the trigger or sensor that was active when you armed. Chime upon remote disarming If the chime sounds after you disarm, IntelliVoice 4 is alerting you that there was an intrusion attempt made on your vehicle while you were away Verbal identification If you receive the chime upon disarming, IntelliVoice 4 will verbally name the trigger or sensor that was tripped while you were away when you turn on the ignition. About the Digital Dual-Zone Proximity Sensor 4 The Digital Dual-Zone Proximity Sensor 4 is a radar sensor that detects movement both inside the passenger compartment and several inches to a foot outside the windows and soft-top (if you have a convertible). IntelliVoice 4 uses this sensor (whether it was standard on your particular G4 system or was added as an option) to detect such movement. The sensor's radar waves pass through nonmetallic materials like plastic, carpet, glass and wood. However, metal and metallic paint, plastic and even some metallic window tinting materials will interfere with or completely block the radar waves. As such, it is not unusual that the Proximity Sensor zones may need a little readjustment when you first have the system installed. In some instances, your Clifford installer may need to try a different location for the sensor. If needed, you or your installing Clifford Dealer can adjust sensitivity of these sensor zones as noted in your owner's manual. To prevent falsing, system sensors are bypassed when the engine is remotely started (if you have the IntelliStart 4 option). Metal above or near the Proximity Sensor will have a significant impact on operation. You should not place coins, CDs, cassettes (due to the iron oxide tape) or other metallic objects above or near where the sensor is mounted. CliffNet Wizard software With the free CliffNet Wizard software and an optional #60-539 CliffNet Replicator, you can plug your Windows PC into your Clifford system to gain extensive feature control: you can select the language (English, Spanish, German or Dutch), set the volumes of the interior and exterior voice, alter the pitch of the chirps, and make other interactive adjustments. See www. clifford. com/wizard for details. Limited factory warranty terms & conditions Clifford vehicle security systems and accessories require professional installation by an Authorized Clifford Dealer. [. . . ] Clifford Electronics makes no warranty against theft. This warranty is not to be construed as an insurance policy against loss. Warranty on installation labor, removal and reinstallation charges are not the responsibility of Clifford Electronics, Inc. © Copyright Clifford Electronics 1999 31-593A/IV4om/0399 [. . . ]