User manual CLIFFORD INTELLIVOICE IQ

[. . . ] World-Class Auto Security TM intellivoice IQ Owner's Manual Table of Contents Standard Features of the IntelliVoice-IQ . 6 Your 4-button/12-channel remote controls . 7 How to use your keychain remote control . 8 How to interpret the parking light flashes . [. . . ] If it does not, the new code you programmed and the one you just entered do not match. In such a case, the system will revert to the previous code. Remote controlled valet mode entry and exit You can even enable or exit valet mode by transmitting channel 9 (LevelShift twice, then button 1). Two parking light flashes will confirm that you have remotely enabled valet mode and the system will say "ENABLED. " A single flash confirms valet mode exit. Keyless entry in valet mode Even if valet mode is enabled, you can still remotely control the convenience features. For instance, simply press button 1 (channel 1) as if you were disarming and the doors will unlock (indicated by one parking light flash) and the interior lights will turn on. Press button 1 again and the doors lock (confirmed by two flashes). You can also use the other channels to activate options such as a remote trunk release or remote engine starting. 12 Remote controlled sensor adjustments Due to ever-changing conditions, all alarms require periodic fine-tuning of their sensors. With other alarms, this requires repeated trips back to the dealer. But IntelliVoice-IQ lets you can adjust sensitivity electronically without even knowing where the sensor is mounted!If the setting(s) of the Proximity Sensor are either too sensitive or not sensitive enough, you may individually test and adjust the settings of each zone with the following procedure: 1. Disarm the system with the remote control, open the driver's window, then select the sensor zone you wish to adjust: a. Interior zone: Transmit channel 11 (LevelShift twice, then button 3). Exterior zone: Transmit channel 12 (LevelShift twice, then button 4). To test the current sensitivity setting: a. Interior zone: Lean into the passenger compartment. You will hear a chirp when the zone detects your presence. Ideally, it should chirp when you lean over the driver's seat, but remain silent when you lean toward the window. Exterior zone: Lean toward the driver's window. You will hear a chirp when the zone detects your presence. Ideally, it should only chirp when you are moving within one foot of the vehicle. If you are not satisfied with the detection level and wish to increase sensitivity, press button 2 on your remote control. Each time you increase sensitivity, the siren will chirp in higher and higher pitched tones to confirm the higher sensitivity setting. [. . . ] Then simply program each remaining and/or replacement remote control as noted in the Adding new remote controls section above. 19 Table of user-selectable features: 1 chirp = OFF, two chirps = ON. Feature Select Row 1 1st momentary Row 2 2nd momentary Row 3 3rd momentary Row 4 4th momentary Row 5 5th momentary Row 6 6th momentary Column 1 1st latched Sound 1: on/off info on page 15 Sound 2: on/off info on page 15 Sound 3: on/off info on page 15 Sound 4: on/off info on page 15 Sound 5: on/off info on page 15 Sound 6: on/off info on page 15 Column 2 2nd latched Add new remote to channel 1 info on page 8 NOTE 1 Add new remote to channel 2 info on page 8 NOTE 2 Add new remote to channel 3 info on page 8 NOTE 3 Add new remote to channel 4 info on page 8 NOTE 4 Add new remote to channel 5 info on page 8 NOTE 5 Erase all channels info on page 19 NOTE 6 Column 3 3rd latched AutoLock on/off info on page 16 AutoUnLock on/off info on page 16 FACT: on/off info on page 13 AutoActivate timed accessory upon remote arming: on/off this feature is for installers only Headlight Reminder: on/off info on page 15 Long-term chirp/voice silencing: on/off info on page 15 Column 4 4th latched Enhanced AutoArming: on/off info on page 10 AutoArm & Lock: on/off info on page 10 15-second entry delay: on/off info on page 10 DSet headlight duration 1sec - 2min (30sec) info on page 9 NOTE 7 Siren duration: 60/30 seconds (1/2 chirps) info on page 15 Set a new secret valet code info on page 12 NOTE 8 D WARNING: If you have remote window and sunroof closure, DO NOT CHANGE THIS SETTING: it requires installer-only adjustment. Please Note: There is a column 5 that contains installer-only features; do not change any of these settings. If you accidentally select column 5, turn off the ignition. NOTE 1: Transmit channel 1 (or other channel of your choosing) of the new remote control. You will hear one chirp to confirm programming of channel 1. [. . . ]