User manual CLIFFORD MATRIX RS 2

[. . . ] Matrix RS 2 O Owner's Guide limited lifetime consumer warranty Directed Electronics, Inc. ("Directed®") promises to the original purchaser to repair or replace with a comparable reconditioned model any Directed® unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided the following conditions are met: the unit was professionally installed and serviced by an authorized Directed® dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed® dealer; and the unit is returned to Directed®, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer's name, telephone number and address; the authorized dealers name, telephone number and address; complete product description, including accessories; the year, make and model of the vehicle; vehicle license number and vehicle identification number. All components other than the unit, including without limitation the siren, the remote transmitters and the associated sensors and accessories, carry a one-year warranty from the date of purchase of the same. This warranty is non-transferable and is automatically void if: the original purchaser has not completed the warranty card and mailed it within ten (10) days of the date of purchase to the address listed on the card; the unit's date code or serial number is defaced, missing or altered; the unit has been modified or used in a manner contrary to its intended purpose; the unit has been damaged by accident, unreasonable use, neglect, improper service, installation or other causes not arising out of defects in materials or construction. [. . . ] Never activate the remote start in an enclosed space. 5. Once the remote engine starting system has successfully started the motor, it will turn the climate controls on. The motor will run for the selected period of time and the parking lights will flash or light solid while the motor is running. (See the Programming Options Section of this guide. ) shutting down the remote engine starting system While the vehicle is running during remote engine starting operation, the system will monitor the vehicle and will automatically shut down the engine if the system receives any of the following shut-down inputs: © 2001 directed electronics, inc. 15 The brake pedal is pressed. The shutdown toggle switch is put into the OFF position. The pre-programmed run time (12, 24, or 60 minutes) has elapsed. is pressed during remote start operation. To shut down the remote start and turn off the engine: Step on the brake pedal, or Press for one second. You may want to enter the vehicle and drive it without shutting off the motor. It is possible to shut down the remote start and drive the vehicle without shutting down the motor. When you are ready to drive the vehicle: 1. Disarm the security system (if armed) by pressing . Enter the vehicle and turn the ignition to the ON position. The remote engine starting system will be shut down when you step on the brake pedal. The vehicle motor, however, will continue to run because the ignition has been turned on. The vehicle will now operate as usual. 16 © 2001 directed electronics, inc. valet take-over A vehicle equipped with the Valet Take-Over system can remain running after the key is removed from the ignition. This feature is useful for occasions when you wish to exit the vehicle for short periods of time, but would like to leave the motor running and the climate controls on. To perform Valet Take-Over: 1. Before turning off the engine, press and release press and release the optional momentary switch). (or 2. Turn the ignition key to the OFF position. The engine will run until the pre-programmed time elapses or a shut-down input is received. (See the previous section for a complete list of shut-down inputs. ) note: This feature will not work if the brake pedal is being pressed. timer mode Timer Mode automatically starts your vehicle engine and runs it for a pre-programmed time period, every three hours for a total of six operation cycles. Timer Mode helps to ensure that your engine will start in the morning after being parked outside during a night of extremely cold temperatures. important!This feature must only be used in open areas, never in an enclosed area such as a garage. © 2001 directed electronics, inc. 17 To enter Timer Mode: 1. Start the vehicle by pressing and releasing 2. Within two seconds press and release . [. . . ] The vehicle is never prevented from cranking when the system is disarmed, in Valet Mode, or if the starter interrupt switch itself fails. Your system has featureready circuitry for the starter interrupt, however installation may require additional labor. Input: A physical connection to the system. An input can be provided by a sensor, pinswitch or by existing systems in the vehicle, such as ignition or courtesy lights. LED: A red light mounted at a discretionary location inside the vehicle. It is used to indicate the status of your system. © 2001 directed electronics, inc. 31 Shock Sensor: This system has a dual zone shock sensor. [. . . ]